搜索资源列表
UDMA
- 用于对udma控制器的编程，采用C语言-right UDMA controllers for programming using C language
2006-5-28_18-33-16_68
- 文档介绍了用单片机和FPGA来实现UDMA控制器的方案，还可以-Document describes the use of MCU and FPGA to achieve UDMA controller program can also be
uDMA
- uDMA的SSI通道应用笔记 -UDMA access the SSI Application Notes
interfacing_fx2_to_atapi_using_udma
- cypress mass storage classes using udma features.-cypress mass storage classes using udma features.
ATP_CF_IG_detail_spec_v2.2
- ATP工业级CF卡资料，支持UDMA模式，嵌入式系统开发CF卡驱动必备。-ATP Industrial Grade CF card detail spec v2.2, support UDMA mode, embedded system CF card driver necessary.
IDE_VHDL
- 此代码为wishbone公司的IDE协议主机端VHDL源代码，有三个版本，实现了UDMA。版权归wishbone公司，请勿用于商业用途。-This VHDL codes with threr versions implemented IDE host protocol，supporting with UDMA。
ATA
- 能够完成硬件数据传输,包括PIO传输、MDMA传输、UDMA传输。程序设计是基于Windows协议，支持PIO传输，由2个block组成。-Able to complete the hardware data transmission, including PIO transfers, MDMA transmission, UDMA transfer. Program design is based on Windows protocol that supports PIO transfers
ide-timings
- PIO 0-5, MWDMA 0-2 and UDMA 0-6 timings (in nanoseconds). These were taken from ATA ATAPI-6 standard, rev 0a, except for PIO 5, which is a nonstandard extension and UDMA6, which is currently supported only by Maxtor drives.
ivtv-udma
- User DMA for Linux v2.13.6.
udma
- 这个示例应用程序演示了使用uDMA控制器进行内存缓冲区之间数据的传递,并通过传输数据测试运行-This sample application demonstrates using uDMA controller for data transfer between the memory buffer, and through the test run data transmission
pata_samsung_cf
- PATA driver for Samsung SoCs. Supports CF Interface in True IDE mode. Currently only PIO mode has been implemented UDMA support has to be added. -PATA driver for Samsung SoCs. Supports CF Interface in True IDE mode. Currently only PIO mode has been
ivtv-udma
- User DMA Buffers for Linux v2.13.6.
ide-timings
- PIO 0-5, MWDMA 0-2 and UDMA 0-6 timings for Linux v2.13.6.
pata_samsung_cf
- Supports CF Interface in True IDE mode. Currently only PIO mode has been implemented UDMA support has to be added. -Supports CF Interface in True IDE mode. Currently only PIO mode has been implemented UDMA support has to be added.
pata_hpt3x3
- Set our PIO requirements. This is fairly simple on the HPT3x3 as all we have to do is clear the MWDMA and UDMA bits then load the mode number.