搜索资源列表
STM32F10x_SPEEX_Firmware_V1.0.
- 基于 STM32 PCM语音编/解码代码，代替硬件录播IC,Based on the STM32 PCM voice encoder/decoder code, instead of recording and broadcasting hardware IC
stm_car.rar
- 基于stm32的库函数的小车系统程序，包括直流电机L298驱动，38KHz调制红外循迹，车轮码盘脉冲计数，液晶显示等模块。,Stm32 the library function based on the vehicle system programs, including the L298 DC motor driver, 38KHz modulated infrared tracking, wheel encoder pulse counting, such as liquid crystal
ssss
- 基于STM32的移动小车的编码器测速与航位推算的设计-STM32-based encoder for mobile car speed and the design of reckoning
stm32-encoder
- stm32F103 2EA Encoder Input. Encoder is step motor control signal.-stm32F103 2EA Encoder Input. Encoder is step motor control signal.
STM32-PWM_Input
- STM32采用定时器管脚的输入捕获功能进行外部脉冲个数的采集，此代码仅采集脉冲个数，准确无误，用到的朋友下来看看，可检测编码器等PWM脉冲个数-STM32 timer pin input capture function for the acquisition of the external pulse number, this code is only collected the number of pulses, accurate, friend came down to see used
STM32-Quadrature-Encoder-Source-Code
- STM32使用正交编码器的完整代码，数码管实时显示-Complete code for STM32 using a quadrature encoder, real-time digital control display
stm32-Encoder
- 利用stm32两路pwm输出作为编码器接口两路输入信号，计数结果可用串口显示，pwm信号可用逻辑分析仪显示-Use-STM32 two PWM output as encoder interface two input signals, count results available serial port PWM signal can be used logic analyzer
encoder
- 基于STM32的高级定时器用作编码器测速，实现电机闭环控制-Based on the STM32 advanced timer as an encoder speed, the motor closed-loop control
stm32-encoder
- stm32 f107vc工作在编码器模式，采用精确算法，并通过lcd显示-stm32 Encoder mode, lcd display
Encoder-stm32
- STM32的程序，能够实现双编码器、多路PWM波输出，等功能。-STM32 procedures to achieve dual encoders, multi-channel PWM wave output, and other functions.
Encoder
- 智能车 机器人码盘测速代码，适用于ARM7，具体管脚分配请参考stm32中文手册Pograming of Encoder-Pograming of Encoder
encoder
- stm32编码器模式及中断配置,可以利用stm32读取正交编码器。CNT寄存器没10000代表一圈，每一圈产生一个中断，可以实时读取每一圈CNT值，以及总圈数(Stm32 encoder mode and interrupt configuration, you can use stm32 to read the quadrature encoder. CNT register no 10000 on behalf of a circle, each lap to produce an inte
STM32正交编码器
- 基于STM32的正交编码器例程，对初学者很有用(STM32-based orthogonal encoder routines are useful for beginners)
stm32正交编码接口（QEI）
- stm32编码器模式设置，还含有相关PDF说明文档以及网页(STM32 encoder mode setting)
encoder
- 驱动双线编码器，使用stm32定时器驱动(stm32 encoder driver)
encoder
- ros机器人开发stm32,encoder(robot of ros encoder)
STM32正交编码器_外部中断
- 这是一个STM32F用外部中断识别光册编码器的程序(STM32 uses external interrupt to identify encoder.)
STM32正交编码器_外部中断
- 用外部中断实现编码器计数，不用STM32自带的编码器接口模式(Encoder Counting with External Interrupt)
STM32 ENCODER
- STM32外接旋转编码器（EC11），外部中断方式识别出正反转，响应速度优良，无丢步现象，无需延时滤波。在强干扰环境下测试正常。注意是仪器仪表面板常见的那种编码器，不是电机测速的那种。(STM32 Read Encoder (EC11), external interrupt mode to recognizes positive and negative rotation, response speed is excellent, no step loss, no delay use. The
STM32增量编码器例程
- 通过增量式编码器A,B,Z项实现对编码值的输出，速度输出和方向判断(The output, speed output and direction judgment of coded value are realized by incremental encoder..)