搜索资源列表
单片机LM35与At89c51温度测量
- 单片机LM35与At89c51温度测量，C语言编写噶！ ,Microcontroller Temperature measurement
LM35
- it is proteus library of LM35 temperature sensor
lm35.rar
- 通过单片机控制，lm35输出的模拟信号将tlc2543转化后输入单片机进行控制，测温精度高，范围0-150度,Through the single-chip control, lm35 output analog signal will be transformed tlc2543 control input single-chip, high precision temperature measurement, the scope of 0-150 degrees
LCD_Thermometer_LM35.bas
- The LM35 of National Semiconductors that is used in this project is a precision centigrade temperature sensor, which has an analog output voltage. It has a range of -55潞C to +150潞C and a accuracy of 卤0.5潞C . The output voltage is 10mV/潞C . The output
LM35
- 基于LM35温度传感器的温控系统设计,硬件加软件设计，看看有用没有啊-LM35 temperature sensor based on temperature control system design
LM35_ADC
- 基于温度传感器LM35与PIC16F877A的应用程序-Based on the LM35 temperature sensor applications with the PIC16F877A
lm35
- temperature code for lm35 atmega8
temperature
- 本程序是基于LM35的温度传感器和AT89S52系统的温度检测程序，温度检测精度为+-0.8摄氏度。-This procedure is based on the LM35 temperature sensor and temperature AT89S52 system testing procedures, temperature measurement accuracy is+-0.8 degrees Celsius.
Temperature_measurement
- Temperature measurement using LM35 sensor.
digital_temp
- 基于AT89S51的数字温度测量系统.本文设计了一套温度测量系统，整个系统采用总线式开发，控制器选用AT89551 单片机，温度采集元件选用温度传感器LM35,显示部分采用七段发光二极管.整个系统由LM35采集的信息,经传送器和A/D转换后送至AT89S51进行数据处理并控制LED显示温度.-AT89S51 based Digital Temperature measurement system. This paper designed a set of temperature measurem
ADC_Serial
- This source code improves an interface for the control of 5 outs from PIC16F877A to on/off 5 house devices (this outs must be optoisolated trough optocouplers like MOC3041). This code also do A/D conversion for the temperature sensor LM35 to temperat
TempLM35
- Temperature LM35 Source Code
TEMP_LCD
- 使用LM35采集温度，并用12864用图形显示出来-Collected using the LM35 temperature, and graphically displayed using 12864
[LM35]Temperature_Warning
- Temperature Sensor,programebled with C and CodeVision AVR use AVR chip
LCD-TempSensor.tar
- A proyect of a temperature sensor (LM35) and LCD with microcontroller PIC16F877, schematic and simulation included in Proteus, Code in PI-A proyect of a temperature sensor (LM35) and LCD with microcontroller PIC16F877, schematic and simulation includ
LM35
- lm35是测温传感器，每升1度，对应的电压就升10mV（这是该器件的特性） 该函数要求 每升0.5度，电压升5mV，并把温度显示在lcd1602上 即A/D转换的分辨率b为0.005v ，也就是温度传感器每0.5度，ADC0804就转换一次（电压-->温度）再去显示温度 这里还得到ds1802检测到的温度与lm35所得的电压进行比较，（在相同的环境温度应是相等） 分辨率b=5mV=VREF/256 所以VREF=1.28V 又因为ADC0802的9号引脚
THERMOMETER
- this a digital thermometer using 8051 micro controller and LM35 temperature sensor -this is a digital thermometer using 8051 micro controller and LM35 temperature sensor
Digital-Thermal-Control-using-8051-microcontrolle
- This project is used to measure the temperature using LM35 analog sensor and ADC0804 Analog-to-Digital converter working in wide range of temperature from 0 c to 120 c and displaying this value on an LCD. It is also used to control the measured tempe
Temperature sensor
- Temperature sensor using lm35 and showing in lcd.
TL7107+LM35仿真
- TL7107 LM35 protues仿真 精度+/-0.2度 实现温度采集(TL7107 LM35 Protues simulation precision +/-0.2 degree realization of temperature acquisition)