搜索资源列表
AVR_USB_JTAG.rar
- 使用国产CH341A芯片实现USB转串口，完全兼容AVR JTAGICE，可以自动升级。 支持芯片: ATmega16(L), ATmega162(L), ATmega169(L or V), ATmega32(L), ATmega323(L), ATmega64(L), ATmega128(L). 原理图还附加了RS232接口，可以方便用户自主选择串口或USB下载程序。 还附加有可自动升级的HEX文件,The use of domestically produced CH341A ch
JLINK-V7
- j_link v7，our usb to 3 jtag 驱动程序及帮助手册-j_link v7, our usb to 3 jtag drivers and help manuals
JTACICEMKII
- JTAGICE mkⅡ与AVR Studio(AVR Studio 4.09或更高版本才能使用JTAGICE mkⅡ)相结合，通过COM或USB可以对所有带JTAG或Debugwire接口的AVR单片机进行在片调试（On-Chip Debugging）和编程。 JTAGICE mkⅡ所支持的芯片的列表见附件-JTAGICE mk Ⅱ with AVR Studio (AVR Studio 4.09 or later to use JTAGICE mk Ⅱ) combined through th
USB.to.JTAG.Interface
- usb to jtag interface circuit
Xilinx USB JTAG 下載端程式
- Xilinx USB JTAG 下載端程式 -The jtag_logic.vhd in this directory describes the logic for a parallel-serial converter to be connected to a FT245BM USB chip from FTDI Inc
userial-firmware-v1.6
- userial is an Free project building an USB to I2C/SPI/GPIO bridge, using the Atmel AT90USB647 chip. Hardware and Software are released under an Open Source licence. It supports the following interfaces: * USB interface (serial emulation) *
AVRminiProg
- AVRminiProg是使用avr单片机作为主控芯片的usb转isp、jtag的程序编程器，usb协议是由软件模拟的-AVRminiProg is the use of single-chip avr as a usb host chip to isp, jtag programmer procedures, usb agreement is simulated by software
man
- a windows program can usb to jtag programming and can program
usb
- 程序说明: 本次实验控制开发板USB，与PC机进行通信，并在显示字符。 目录说明: 工程在\project文件夹里面 源文件和管脚分配在\rtl文件夹里面 下载文件在\download文件夹里面,.mcs为PROM模式下载文件,.bit为JTAG调试下载文件。-Procedure Note: In this experiment, control development board USB, and PC, to communicate, and display char
ulink2ZHINAN
- Keil ULINK2 USB-JTAG 适配器通过USB 端口将PC机与目标硬件（经JTAG 或 OCDS）连接起来 ，可以实现，下载程序到目标硬件上进行测试。 -Keil ULINK2 USB-JTAG adapter through the USB port to PC, with the target hardware (via JTAG or OCDS) link can be achieved, download program to the target hardwar
usb_jtag
- usb通过Jtag口进行下载的源码程序，可以方便的通过它下载到EPROM里面-usb port for downloading through the Jtag source programs can be easily downloaded to the EPROM which through its
usbtoJtag
- jtag 到 usb 仿真器 原理图，经过验证-jtag emulator to usb schematic, proven
jtagtousbdriver
- jtag to usb驱动程序 经过验证-jtag to usb driver verified
STM32-H103
- STM32-H103 board is entry level development board for the new ARM Cortex M3 family of devices produced by ST Microelectronics Inc. With STM32-H103 you can explore the features of STM32 family on budged, the board have everything necessary to bu
stm32V1_2
- 这是我自已为实验室画的基于STM32的PCB，现在将原理图及PCB全部分享，图是用PROTEL 99SE绘制的。可能会有布线不合理之处，仅供大家参考。 实验板资源介绍 1）CPU为100脚STM32F103XX 2）TFTLCD 3）SD卡 4）4X4键盘模块及四个独立按键 5）ISP下载口及20脚JTAG下载口 6）RS232接口、RS485接口、PS/2接口、USB接口 7）I/O口驱动的蜂鸣器 8）I2C口驱动的AT24C02 9）
lpc2388+sim508
- Lpc 2378-88 mini pc - /mmc-sd/usb a,b/10-20mbit Ethernet/i2c display/ up to 36 v dc-dc/rs232/jtag/ etc/ + molex 80 pin conector/for sim 508/548 ang you have lpc2378 mini pc + gsm +gps I do hope its very interest information for community
jlink_v8
- usb to jtag for arm J-Link a circuit.
STM32-H103
- STM32-H103 board is entry level development board for the new ARM Cortex M3 family of devices produced by ST Microelectronics Inc. With STM32-H103 you can explore the features of STM32 family on budged, the board have everything necessary to bu
DriversFTDI
- FTDI drivers for FT2232 module. USB to JTAG.
lattice_usb_ft2232_cable_sch
- Lattice USB FT2232 JTAG Programming Cable Schematic