资源列表
CATIA二次开发技术基础
- CATIA二次开发，VBA开发CATIA(CATIA secondary VBA development)
PedestrianTrackingFromMovingCameraExample
- 本代码可以在移动车辆中进行车辆行人的识别(Pedestrian vehicle identification)
面元法空气动力学例程-matlab
- 面元法计算升力阻力等，空气动力学小算例，模型基于三段模型，使用方法见标注
ACCcontrol
- 可实现较简单的汽车巡航要求，简单的跟车行驶(Simple cruise requirements)
火箭弹弹道计算程序c++
- 助推飞行器、火箭弹，增程炮弹的外弹道飞行程序(This paper introduces the optimization scheme for the optimization of the trajectory of a booster vehicle)
EP_M
- 计算各向同性硬化弹塑性模型，利用J2流动理论(The elastoplastic model of isotropic hardening is calculated by using J2 flow theory.)
PMSM_SMO
- 实现永磁同步电机的无位置控制，采用滑模算法计算转子位置角度，精度高，相应速度快。(Realize position control of permanent magnet synchronous motor, rotor position Angle is obtained by using the sliding mode algorithm, high accuracy, the corresponding speed.)
机械原理凸轮与连杆机构程序设计
- 代码基于matlab，来源于哈工大机械原理课程设计，应用于机械传动的设计与开发(The code is based on MATLAB, which comes from the design of Harbin Engineering University mechanical principle course and applied to the design and development of mechanical transmission.)
can-sc15-2.6
- 商用车控制系统局域网络（CAN 总线）通讯协议的应用层—诊断部分(Commercial vehicle control system local area network (CAN bus) application layer - diagnosis part of communication protocol)
RTCA-DO-160F
- 民用航空测试标准。机载设备的环境条件和测试程序(RTCA-DO160F avionic test standard)
free_wall
- 特征线法，计算自由边界子程序，当边界压力人为给定时，计算自由边界点的位置(MOC program,used to compute the free boundary which pressure distribution is set artificially)
car-seven-model
- 分析汽车横摆角速度和质心侧偏角，课用于研究汽车ESP系统(Analysis of the angular velocity of the car's yaw and the side angle of the center of mass)