资源列表
松下PLC弯折机程序
- 松下PLC弯折机程序，控制一个步进电机，做半自动弯折设备的可以借鉴
package_emd
- 基于matlab的EMD(经验模态分解)(It gives some files on EMD by the team of G Rilling,and it show the algorithm on EMD in detail.)
Stepper
- proteus仿真P0.0口按键控制/P2.0-P2.3输出方波/可驱动步进电机，也可以做为按键控制PWM输出，延时方波，不用定时器和中断(P0.0 port button control /P2.0-P2.3 output square wave / drive stepper motor, can also be used as keys to control PWM output, delay square wave, without timers and interrupts)
FlexCAN1
- 飞思卡尔5604B CAN收发程序，CAN0发送CAN1接收，官方版(Freescale, MPC5604B, CAN, send and receive)
invertervdcctrlislanding
- 基于pscad利用PWM调制方法实现的逆变并网的仿真模型(Simulation Model of Inverter Grid Based on pscad Using PWM Modulation Method)
DualMonitorTools-2.5
- Administrador y Controlador de 2 Monitores
FX_MPC5604B_I2C
- 单片机通过I2C接口向AT24C02发送一个字节的数据 并把数据读出，检测读出的数据是否正确，正确则点亮指示灯。(The microcontroller sends a byte of data to the AT24C02 through the I2C interface And read the data, check whether the data is correct, correct the light indicator.)
矩阵计算
- 可以进行简单的矩阵计算，当一个矩阵计算器来使用。(Simple matrix calculations can be performed when a matrix calculator is used.)
FX_MPC5604B_SD
- 单片机通过DSPI接口向2G的SD卡写入一个扇区的数据 之后将数据读出，并检验，如果数据正确，则点亮指示灯(SCM through the DSPI interface to 2G SD card to write a sector data The data is read out and checked, and the indicator light is lit if the data is correct)
7款非常漂亮的CSS3鼠标hover图片动画特效
- CSS3鼠标hover图片动画特效，特效有七款，详细的代码实例，仅供参考。(CSS3 mouse, hover pictures, animation effects)
温度传感器
- 两种xs128的温度传感器测量温度的方法，适合初学者，一看就懂(Two xs128 temperature sensor temperature measurement method, suitable for beginners, a look at understand)
landmanagement
- 对土地利用信息进行管理的windows窗体应用软件系统(System for managing land use information)