资源列表
modBus-RTu
- modbus RTU 通信,发送，接收、接卸-modbus RTU communications, send, receive, unload, etc.
vb-shuijidam
- 水晶打磨控制系统,VB写的串口程序,能够将输入数据通过串口以16进制发送,同时从串口接收数据-Crystal grinding control system, VB to write the serial program, the ability to input data sent through the serial port in hex, while receiving data from serial port
smart
- 本程序是基于LABWINDOWS/CVI 的，主要是通过串口采集下位机信息，然后显示状态信息并通过串口发送命令字节。-The program is based on LABWINDOWS/CVI.It get message from RS232and display status,then send command by RS232.
VB-FP0
- 此源码是VB与松下PLC FP0系列通讯用的源代码。-The source is VB Series with Panasonic PLC FP0 communication with the source code.
Serial-with-mscomm
- 在Labview中利用Mscomm控件实现串口通讯，解决了VISA通讯不能利用中断的缺陷，可以实时响应串口数据。-In Labview using Mscomm control serial communications, communication can not be used to solve the interruption of VISA defects, real-time response to serial data.
nimodbus121
- LABVIEW modbus 软件包，可以相关485设备通讯，NI已经做好底层工作，直接使用-LABVIEW modbus soft，direct use
RS
- 这个C++程序建立了高斯白噪声信道模型下的RS码的编码及译码算法，并且给出了其比特误码率性能。-This program has realized the RS code,the coding and decoding mode (and furthermore has simulated the ber performance of decoding )
DTMF
- 对DTMF电话通信过程的仿真，并通过MATLAB的GUI界面模拟电话拨号，同时考虑信道的信噪比对接收端拨号探测的影响。-Using MATLAB to simulate DTMF telephone communications. Simulate dailing interface by GUI, and consider effect of channel SNR on signal detection at receiver side.
Delphi-DTU
- GPRSDTU客户数据中心源程序Delphi实现，实现了DTU上传数据的接收和显示以及对DTU的远程设置功能，其中动态链接库wcomm_dll.dll实现了与远程DTU的通信。-GPRSDTU customer data source, DTU upload data reception and display, as well as the remote setting function of the DTU, including dynamic link The library wco
bpsknewnochannel
- 实现物理层网络编码的仿真，此为无信道编码环境下实现的-network coding
modify_IMEI
- 读取，修改串号，支持各种芯片，软件是通过指令修改对IMEI，请大家下载尝试-Read, modify, serial number, and supports a variety of chips, software commands to modify the IMEI, please download attempt
LVDS
- LVDS的收发接口程序，适用于数据帧发送协议的告诉数据传输-LVDS transceiver interface program for the data frame to send the agreement to tell the data transmission