资源列表
vehicle-control-for-parallel-system
- 并联式混合动力客车整车控制程序，采用C+matlab程序架构，实现CAN通讯、能量分配、故障检测、故障诊断与故障处理等功能。-VCU program for Parallel hybrid passenger
ArduCopter-2.7.3
- APM2.0是基于Arduino平台的无人机飞控主板板源代码。-APM2.0 is based on the Arduino platform for UAV flight control board board source code.
STM32-clock
- 基于STM32实现电子时钟的设计，可以通过按键、或者串口来进行时间设置-STM32-based electronic clock design, can be key, or serial port to set the time
SDK.2.62
- MACH3二次开发的SDK软件开发包，对于MACH3二次开发的朋友很有用-MACH3 secondary development SDK software development kit for MACH3 secondary development of useful friends
AtomCNC
- 经典开源多轴联动AVR步进电机运动控制程序,包括G代码处理、主轴控制、限位开关控制等子程序-AVR CNC controller with Gcode
stm32-foc-firwmare-libraries-v2.0
- 永磁同步电机矢量控制程序，位置与角度判断可通过霍尔位置传感器，编码器得到，其中也含有无位置传感器程序-Permanent magnet synchronous motor vector control program, to determine the position and angle through the Hall position sensors, encoders get, which also contains the program without position sensor
fuzai-stc52
- stc89s52单片机开发，电子负载，库仑计。 1602液晶显示。电流电压显示。放电时间显示。-stc89s52 microcontroller development, electronic load, Coulomb gauge. 1602 LCD. Current and voltage display. Discharge time display.
HT16C23源程序
- HT16C23驱动源程序，用STC单片机，Keil软件编写
ethercat-Master-Code_Version-3.10
- 现场工业以太网，ethercat主站代码windows平台实现-The industrial Ethernet, the Windows platform to realize ethercat master station code
ethercat-slave-source-code
- 工业实时以太网ethercat从站源代码。-Real-time industrial Ethernet ethercat slaves the source code.
MIPI-READ
- SSD2828读出程序，可以读出TFT LCD MIPI接口的DRIVER IC内寄存器的数值出来-SSD2828 READ
mppt_stm32
- 基于stm32的太阳能mppt控制程序，adc采集，oled显示-Stm32 based solar mppt control program, adc acquisition, oled display