资源列表
getpoint
- 在机车车辆动力学中，用matlab获得轮轨接触点-get the contact point of wheel and rail
fspmmotor_hysteresis_linear
- 永磁直线电机的电流滞环控制，直线电机的模型是用simulink自己搭建的。-Permanent magnet linear motor hysteresis current control
fspmmotor_DTC_Te3
- 永磁直线电机的直接推力控制例程，直线电机的模型是自己编写的。-Permanent magnet linear motor control routine of direct thrust linear motor model is written in their own.
NewModel_PUBLIC
- 四旋翼飞行器在MATLAB下的建模程序，非常好，非常真实-Four-rotor aircraft under the MATLAB modeling program, very good, very durable
Patton_copula_toolbox
- PATTON各种时变COPULA的M文件-PATTON variety of time-varying COPULA M-file
aa-bp
- 使用蚁群算法及改进的蚁群算法优化BP神经网络的程序-Ant colony algorithm to optimize the BP neural network program
Zernike
- 绘制zernike曲面,用于分析泽尼克多项式表示光学像差的gui程序。-plot zernike face for analysis basic optical aberration
onedimensional-photonic-crystal-
- 采用传输矩阵法，用matlab编程计算的一维光子晶体的能带结构，方法简单，速度快，同时可计算透射系数-Using transfer matrix method, calculated with matlab programming one-dimensional photonic crystal band structure, the method is simple, fast, and calculate the transmission coefficient
LMD
- LMD算法，对信号进行LMD分解，分解的层数可由自己定，并且能得出分解波形~-LMD algorithm, LMD decomposition of the signal,the decomposition of the layers can be set for oneself, and can come to break down waveform ~
FOF_syn_communication
- 在MATLAB中通过四阶龙格库塔法，计算时滞微分方程,-In MATLAB by fourth-order Runge-Kutta method to calculate the delay differential equation
retangleplace
- 本程序为使用剩余矩形排样法排样的矩形件排样程序，应用matlab软件编程制作。程序能够根据用户输入的排样方案对给定的25块矩形件在宽为15的板材中进行排样，并绘制矩形件排样图。-This procedure is used to drain the remaining rectangular nesting nesting kind of rectangular pieces of the program, application software programming matlab prod
rcs fdtd
- 在matlab环境下用fdtd法计算三维rcs，散射体为圆柱或矩形柱，边界条件采用UPML。-In the matlab environment with three-dimensional method fdtd rcs, scattering cylindrical or rectangular column, the boundary conditions used UPML.