资源列表
6
- 本程序用pca，kpca,svm,pls,fisher实现cstr和csth过程的故障检诊断，检测率为百分之九十九，故障识别率为百分之九十四-The program use pca, kpca, SVM, PLS, fisher realize CSTR process inspection and CSTH fault diagnosis, detection rate was ninety-nine percent, the fault recognition rate is ninety-
GA1E1
- 用Ｋ均值和遗传算法实现了半监督聚类算法，这是个一个已经发表的论文的源程序-Using K-means and genetic algorithm to achieve a semi-supervised clustering algorithm, this is a paper published source
Hardware_USB_System_Architecture
- The book describes the USB interfase and how to develop drivers, communications, power distribution, data transfers, packet definition and recovery and a software overview.
3DS
- 用c++编写的基于opengles加载3ds，适用于嵌入式。-The written with c++ based on opengles load 3ds, applicable to embedded.
ang_continue_measure_ver2.0-
- 5124采集程序，频谱显示，时域波形显示，存储，通道之间的相位差计算-5124 collection procedures, spectrum display, time-domain waveform display, storage, compute the phase difference between channels
sever
- TCP模式下，文件传输的服务端程序，可以传任一格式文件，不受文件格式限制-TCP mode, the file transfer server program, you can transfer files of any format, file format is not restricted
chuankou2
- STM32F103的串口2中断读写，并且记录中断次数。-STM32F103 serial 2 interrupt to read and write and record the number of interrupts.
Source
- 本代码为了便于在VC++访问com组件的属性和接口函数而编写的类，使用时 只需要包含头文件"automation.h",类名为CAutomation。-Written this code in order to facilitate access to the properties of the com component and interface functions in VC class, use Only need to include the header file to "a
Chat
- 一个简单的vc++利用udp协议的聊天程序，在vs2010下编译通过-A simple vc++ use the udp protocol chat program, compiled in vs2010 by !
United-Total-Shopee
- Billing detailsnproject
signal_process_matlab.rar
- <信号分析与处理：MATLAB语言及应用> 本书将信号分析与处理、信号与系统、与matlab语言紧密结合。提供大量matlab应用程序,err
small8
- This a sample microprocessor with a bi-directional data bus and RAM in software created in VHDL run on a cyclone 3 FPGA. -This is a sample microprocessor with a bi-directional data bus and RAM in software created in VHDL run on a cyclone 3 FPGA.