资源列表
jianpan
- 一个4*4键盘程序，当有按键按下时将在数码管上显示出按下的字符
led
- Ljd sy 5100s led示例程序
display7
- 单片机时时通信程序 向欻耨发一组8位数据 可在P1口电量相应的灯-Single-chip communication procedures from time to time made to the Nou suddenly a group of 8-bit data can be in the P1 corresponding light power I
paomadeng
- 使用51单片机编写的跑马灯程序，顺序点亮8个发光二极管，并闪烁-Marquee prepared using 51 single-chip program, the order of 8 LED lights, and flashing
electronic-clock
- 这是一个简单的51单片机编写的程序，可实现时间的准确显示-This is a simple program written in the 51 SCM can achieve an accurate display of time
bujingC
- 简单设计步进电机的驱动C程序！方便调试和再添加学习！-Simple design stepper motor drive C program! Easy to debug and add learning!
Timer-control-traffic-lights
- 东西向绿灯亮 5s 后，黄灯闪烁，闪烁5 次亮红灯， 红灯亮后，南北向由红灯变成绿灯，5s 后南北向黄灯闪烁， 闪烁5 次后亮红灯，东西向绿灯亮，如此往复-East-west green light 5s after the flashing yellow light flashes 5 times red. Red light, north and south from the red to green, 5s after the north and south to the fl
MCU-button-interface-program
- 这是一个51单片机按键接口的源程序，是用C程序写的，是我自己写的，可以在51单片机上成功运行。-This is a source of the 51 microcontroller keys interface is written in C program, I wrote it myself, you can run successfully on 51 SCM.
2
- 程序功能为基于10位的高精度DAC数模转换器，实现频率比较高的周期周期性信号输出，分别实现锯齿波和三角波输出，通过控制插入的软件延时可以达到调节输出信号频率的目的。-Program function is based on 10-bit precision DAC digital-to-analog converter, to achieve a relatively high frequency periodic periodic signal output, respectively, to
display
- ds1302做的时钟，开机动画程序，显示用共阳6位8段数码管-ds1302 clock to do, boot animation program
IIC
- 由于51单片机没有IIC硬件接口，所以通过时序来模拟IIC时序图来实现功能！-Because no IIC 51 MCU hardware interface, so the timing to simulate the IIC sequence diagram to realize the function of!
Bluetooth-Car-program
- 用51单片机C语言写的蓝牙小车控制程序，可用蓝牙模块把带有蓝牙模块的小车连接手机来控制-With 51 single-chip C language to write the Bluetooth Car control procedures, the use of Bluetooth module with Bluetooth module connected to the phone to control the car