资源列表
testmain
- vxWorks下可用的串口测试程序，初学者易用-vxWorks serial testing procedures available under
scanner
- 扫描显示译码控制部分用一个频率1KHz的信号扫描一个多路选择器，实现对六位已经锁存的计数结果的扫描输出-Scan revealed a decoding control part of the signal with a frequency of 1KHz scan more than one MUX to achieve a count of six has been the results of the scan latch output
Ctw8816--palcV
- TW8816关于CVBS视频格式到到TFTLCD的有关内部寄存器的配置表 -CVBS video format on the TW8816 to TFTLLCD register the relevant internal table
FIR_lowpass_part
- 实现FIR滤波器的并行算法，这里是一个64阶的低通滤波器-FIR filter of parallel algorithm
BCD-counter
- 一个2位的BCD码十进制加法计数器电路，输入为时钟信号CLK，进位 输入信号CIN，每个BCD码十进制加法计数器的输出信号为D、C、B、A和进位输出信号COUT，输入时钟信号CLK用固定时钟，进位输入信号CIN. -A 2-bit BCD code decimal adder counter circuit input as the clock signal CLK, a carry input signal CIN, D, C, B, A, and the carry output s
main
- 主程序等待外部中断触发的噪声报警，LED显示运行状态-Main program wait for an external interrupt trigger noise alarm, LED display operating status
Text1
- 给遥控解码，在十米之内，只要有红外线感应，就能读出码.-To the remote control decoder, within the ten meters, as long as there are infrared sensors, knows the code.
dac8501
- 采用MSP430作为控制器，通过SPI接口控制16位串行DAC-adc8501,输出相应电压-Using MSP430 as the controller through the SPI interface control 16 serial DAC-adc8501, the corresponding output voltage
automusic
- 基于VHDL语言自动音乐播放器，使用惠灵顿公司的FPGA器件，可以实现两首音乐手动切换，以及音符数码管同步显示-Based on VHDL automatic music player, use Wellington s FPGA devices, you can achieve two music manually switch, and notes synchronized digital display
B20beiyong
- 18B20.可移植的标准模板程序，用于51系列单片机-18B20. Portable standard template program for 51 series
IIC_AT24C02
- 写入数据到存储器中，再从其中读取数据，并送到指定端口中。 -Write data into memory, and then reads the data from, and sent to a specific port.
DSP28_Adc
- 对2812的AD模块进行初始化,运行于启动/停止模式,级联方式-2812 AD module to initialize, run in start/stop mode, cascade mode