资源列表
zhuanpan.rar
- 增量式光电编码器输出四分频脉冲计数，分别为A，B两路信号,Incremental optical encoder pulse count output frequency of a quarter, namely A, B two-way signal
ILI9486LPBOE3.5_Initial
- 已经量产过的ILI9486L配京东方的初始化代码-inital for ILI9481 driver
Sequencedetector
- 用VHDL语言实现的序列检测器 （以1010111为例）-Sequence detector (for example 1010111)
Multiplier
- 4 bit multiplier written in behavioral VHDL, using logic gate logic. inputs are A and B (4 bit each) and output is C (8 bits).
FFT
- 该文件是用C语言实现快速傅里叶变换的源代码，需要的朋友快下载-The document is used C language to achieve fast Fourier transform of the source code, need friends fast download
new_complex_mult
- new approach to compute complex mult with only 3 real mult
单片机电子温度计C源代码
- 本代码是基于STC89C52的简易单片机温度计的源代码。其中八段管的管脚顺序按照实际情况作调整，本代码仅供参考
code
- 本代码是简单单片机实现电子温度计的C源代码，单片机采用国产STC89C52芯片。8段管的管位要根据实际情况来做调整，本例仅供参考。-This code is a simple electronic thermometer MCU C source code, using domestic STC89C52 microcontroller chip. 8-bit segment tube tube to make adjustments according to the actual situat
dianyabiao
- 四路电压表的设计，利用C语言，完成基于单片机的电压表的设计-Design Quad voltmeter, using C language, the completion of microcontroller-based design voltmeter
trans_f
- By comparing elapsed times one can say that Hooke and Jeeves methods converge faster than other methods and the slowest one seems to be Nelder and Mead Simplex Method. In this part of the assignment we are going to reach the solution by using Nelde
Shuzidianrong
- 基于c51的单片机数字电容测试仪设计，有兴趣的可以参考一下-C51 microcontroller based digital capacitance tester design, are interested can refer to
com_claw
- 51单片机应用，控制步进电机丝杆滑块上升，控制舵机爪子开合，通过串口获得命令，波特率9600，偶校验，可用串口助手使用也可作为从机。-8051MCU application,MCU control moto up and down.MCU control claw open and close. bote rate is 9600,enen chek. can be used with com helper or as a sub_MCU.