资源列表
8-way-control-lantern
- 8路移存型彩灯题目要求两种花型，本次实验分别实现这两种花型，它的设计主要采用74194接成扭环形结构的移位寄存器来实现，整个电路主要由编码发生器、控制电路、脉冲发生器构成可以实现控制8个以上的彩灯，并且可以组成多种花型。 -8 subject lantern-type shift registers require two flower type, respectively, the experimental realization of the two flower types, it i
leftrotate
- VHDL code of left rotate
VGA
- VGA时序verilog hdl，实现显示器vga接口的控制，-VGA timing verilog hdl, vga interface to achieve the display control
Text1
- 使用51单片机实现对LED流水灯的按键控制-Single chip using 51 keys on the LED light water control
Program
- 用VHDL状态机设计一个8位序列信号检测器。-Design a state machine in VHDL 8-bit serial signal detector.
edmxk1b
- 产生脉宽和脉停，根据不同档位可以选择不同的脉宽和脉停。占用资源少。已经实际使用-To generate pulse width and pulse stopped, according to the different stalls can choose a different pulse width and pulse stop. Occupy less resources. Have been the actual use of
LCD-MESSAGE
- This using Keil uVision 3 and Atmel Flip 3.4.3 The code is tested using 8051 microprocessor chip. 1) Copy and paste the attached code to Keil uVision. 2) Use the link below to configure in Keil for the 8051 chip. download here: https:/
PaoMaDeng_C
- 基于单片机学习板的Keil环境下可以成功调试，是跑马灯C语言实现的演示程序-The Keil Microcontroller learning board-based environment can successfully debug, Marquee C language implementation of the demonstration program
yuanhongwaibizhang
- 机器人避障，红外线传感器检测，大学生版智能机器人检测程序-robot
js
- 绞车传感器的计数程序代码 计算四倍频的程序 -Winch sensor count code to calculate the fourth harmonic of the program
counters
- 用VHDL编写的最大值为255的计数器，供初学者参考-A 255 counter of VHDL，for Beginners Reference
DZQ
- 单片机的开发，实现基本的小功能，各个端口的使用-SCM development, achieve the basic small features, use each port