资源列表
K-MeansCluster
- K-Means是聚类分析中重要的一种方法，此源码是K-Means聚类分析的C语言实现。-K - Means clustering analysis is the most important way, this source is K - Means clustering analysis of the C language.
gongwen
- 办公系统的公文处理，不需要任何特殊的知识 -office document processing system do not need any special knowledge
ipdephi
- ip电话源代码，可以免费打电话的，仅供研究之用 -ip phone source code, free phone, used for research purposes only
sl.v
- 路灯控制器 采用了状态机的概念编程，其中采用了信号检测进程防止干扰信号驱动芯片工作-lights controller state machine used the concept of programming, where the signal detection processes to prevent signal interference driver chips work
DropFile
- 在对话框中拖放文件的简明讲解，添加消息函数，简单几句代码-drag on the concise document, add the information function, in a few simple code
Rop2
- 了解画图的模式！对于GDI初学者很有帮助！-understanding of the mode of drawing! GDI helpful for beginners!
wpcapsrc_3_2_alpha1
- winpcap3.2的源代码,可以供研究网络捕获程序之用-winpcap3.2 the source code, can capture network for research procedures used
s3c2410.h_chip.H
- s3c2410内部ADC转换的驱动程序，在arm2410实验板上测试过。-s3c2410 internal ADC conversion of the driver, the board arm2410 experiment tested.
LV24000Eva_v014
- LV24000的单片机DEMO程序，用C写的，实现所有FM功能。-LV24000 SCM DEMO procedures, written in C, all FM function.
status_watcher
- Linux下的GTK系统监视器 v0.1-Linux system monitors the GTK v0.1
r200512168042
- activex控件呢?客户端上ie中关于activex的设置我全设为启用了 小弟在另外一台安装cb的win2000... -client on activeX ie on the set I had the whole set to open in another one brother-mounted cb the WIN2000 ...
NC
- 一个简单得数控中心源代码，该程序可以控制两轴，最多可以控制4轴-a simple NC Center in the source code, the program can control two axis, can control up to four axis