资源列表
csd_of_communication_signals.r
- 对数字调制信号计算循环谱相关，并画出三维图以及二位截面图,Digital modulation signal to the cycle spectral correlation calculation, and draw three-dimensional map, as well as two sections
OFDM.rar
- ofdm.m为主程序，可以运行，将得到迭加噪声之后的误码率曲线，并与理论QPSK加高斯白噪声误码率曲线比较，两者将重合,ofdm.m-based program, you can run, will be after the noise superposition error rate curve, and with the theoretical QPSK plus white Gaussian noise bit error rate curves, which will coincide
GPSPosition3.0.rar
- GPS单点定位程序,利用伪距测量进行单点定位。写得很优秀，推荐一个,This is a Gps position code.
fault.zip
- 基于PSCAD的双馈风力发电机的低电压穿越模型,PSCAD based on the doubly-fed wind turbine through the low-voltage model
code.rar
- 基于离散小波余弦变换DCT的数字水印算法，实现了水印的嵌入提取等过程。毕业设计源代码,Discrete Cosine Transform Based on Wavelet Digital Watermarking Algorithm in DCT, the watermark embedded in the realization of the process of extraction. Graduation Project source code
sa_gibbs.rar
- 本程序是关于地球物理反演模拟退火程序，和已经上传的遗传算法、Tarantola非线性反演是一整套。本着学习交流之用，切勿用于商业用途。,This procedure is about the geophysical inversion of simulated annealing procedures, and genetic algorithms have been uploaded, Tarantola is a set of non-linear inversion. In the exc
Line2Pline.rar
- CAD小程序：批量将直线转化为多段线，首尾相接的将会被合并为一条多段线。,CAD applet: volume will be a straight line into a multi-segment line, both the phase will be more than one paragraph into lines.
s1002.rar
- 欧洲高速列车车轮标准踏面S1002数据生成及分析,highspeed wheel tread analysis
float2HEX.rar
- 实现浮点数和在计算机的十六进制之间的转换，方便用户输入十六进制给单片机，利用单片机进行强制转换,conver float to HEX
Orbitcompute.rar
- 卫星轨道动力学数值计算，包括轨道动力学计算的基本数学模型、轨道计算方法、轨道根数与位置矢量、速度矢量的关系等！,Satellite orbit dynamics numerical calculation, including the orbital dynamics calculation of the basic mathematical model, orbit calculation, orbit and position vector, velocity vector of the r
WaterPro7.0
- 水和水蒸气热力性质计算软件，特别有用，不论是暖通专业还是锅炉专业都用的着-Calculation of thermodynamic properties of water and steam software, particularly useful, whether HVAC or boiler used in the professions
mat-to-labview-waveform
- 该程序的功能是将matlab的mat文件转化成labview中的波形文件，便于在labview中应用mat文件里的数据。-it can change the mat file to vi file which is used in labview.