资源列表
mmse和zf预编码参考程序
- mmse和zf预编码参考程序
THS1206
- 运用verilog对ad1206芯片进行控制，对信号进行采样的信号，已通过测试-Using verilog on ad1206 chip control, the signal is sampled signals, has been tested
delay
- 在ns2下计算AODV传输时延的awk文件.-AODV in ns2 calculated transmission delay of the awk file.
bpsknewnochannel
- 实现物理层网络编码的仿真，此为无信道编码环境下实现的-network coding
Rrscc_encoodeS
- RSC编码的演示程序源码，用于于turbo编码。 -Demonstration program of the RSC-coded source used for turbo codes.
jibenfangzhen
- 这两个是通信中基本仿真程序，一个是单边带调幅和双边带调幅的对比，另一是使用希尔伯特滤波器进行的单边带振幅调制解调．-these are two basic communication simulation program, is a single-sideband AM band and bilateral AM contrast, Another is the use of Hilbert's single sideband filter amplitude modulation an
rr
- 给出了 =10 dB时三种方案的中断概率随传输速率R变化的情况，由图可以看出，速率R越小，中断概率越小，且本文建议的方案在相同传输速率情况下，中断概率最小-Outage probability given the situation with the transmission rate R = 10 dB change when the three programs, it can be seen from the figure, the smaller the rate R, the outa
clipping_ccdf
- 降低ofdm系统峰均功率比的clipping算法。-lower peak to average power ratio of clipping algorithm.
channelcompare
- 這是一個描述MIMO Channel的不同狀況下的一個程式(不同channel間作比較: UHR - ULR - CLR ) , 也分別適合於不同的傳輸模式~-This is a descr iption of MIMO Channel under different conditions of a formula (different chann el intercropping comparison : Nineteen-ULR - CLR), were also tailored to d
paratest
- 有关并口通讯的例程，在vxworks下试过，好用-the parallel communication routines, tried under the VxWorks and ease of use
csma
- this codesimulate csma algorithm.
duoxiancheng-makefile
- 多线程MAKEFILE,LINUX的编程小程序-MORE XIANCHENG MAKEFILE