资源列表
110kv
- 110kv变电站模拟屏仿真软件，完成对模拟屏的控制及显示。-The 110kv substation simulation screen simulation software to complete the simulation screen control and display.
sanshe
- 基于gtd模型music算法提取目标散射中心的程序-Music algorithm based gtd model procedures for extracting the target scattering centers
bridge
- ansys分析变截面连续箱梁桥的命令流,包括建模，求解，和模态分析等-ansys analysis of variable cross-section continuous box girder bridge command stream, including modeling, solving, and modal analysis
cengheban
- 计算层合板刚度，和最先一层失效载荷！程序具有通用性，能够对任意工程弹性常数和几何尺寸的层合板进行刚度和强度分析！非常适合最为哈尔滨工业大学复合材料与工程专业的复合材料力学上机大作业-Laminate stiffness calculation, and the first layer of failure load! Program is versatile, capable of any engineering elastic constants and geometry of laminat
VeMAC
- 车载TDMA协议VeMAC的matlab仿真，包括高速公路和城市两种场景-Vehicular ADHOC network TDMA protocol VeMAC matlab simulation, including highways and urban two scenarios
QAMreceiver
- 16QAM信号最佳接收机，包括信号生成（+成型滤波）、上载波、过信道、下变频、匹配滤波、定时同步等过程-the optimal receiver for 16QAM, including signal source( shaped filter),modulation,AWGN channel, matched filter, timing sychnoization and so on
double-spectral
- Matlab双谱分析，高阶累积量的定阶，用相邻奇异值差最大定阶，绘制双谱（等高线图，双谱图，相位图，切片图）-Matlab double spectral analysis, fixed-order cumulant, with the largest difference between adjacent fixed-order singular value, drawing double spectrum (contour maps, dual spectra, phase diagram,
LMS_PI
- 功率倒置算法的LMS实现，因为自己遇到了点问题，本人一直在找这个程序，没找到，故自己重新检查把问题发现了，相信如果你要实现的话可能会遇到这个问题祝你好运！-Power inversion algorithm LMS implementation, because they encountered a point problem, I ve been looking for this program, did not find it to re-examine the problem yourse
Struve01
- 计算STRUVE函数，表达式为H0或者H1的表达式，特殊函数-Calculation STRUVE function H0 or H1 expression is an expression, special functions
beamResponse
- 模态叠加法求欧拉梁的振动响应，对于初学者非常有帮助-Modal superposition method of Euler beam vibration response, very helpful for beginners
compressed-sensingDOA
- 基于压缩感知，利用最大似然函数进行DOA估计的两种方法-Based on compressed sensing, using the maximum likelihood function of the two methods for DOA Estimation
gansheyi
- 运用干涉仪进行测向交叉定位，并进行一些简要分析-Using interferometer Crossing Location, and make some brief analysis