资源列表
合成孔径声纳的基带信号,以及回波信号的三维图形
- 用于声呐的算法,只是个初稿,中文说明不能小于20字,(The algorithm for sonar is only a preliminary draft, and the Chinese explanation should not be less than 20 words.)
Matlab Files
- this file can be used for making zero one matrix of movie lens data set
final2_1
- 随机攻击的matlab代码,已调试。。。。。。。。。。。。。。。(Random attack matlab code)
ThreePhasePowerControl_dqCloop
- dq功率控制双闭环三相并网逆变器,内环为电流环,PI控制器,dq解耦(Three phase inverter with d-q double-loop PI controller, grid tied.)
操作系统:精髓与设计原理(中文第七版)
- 操作系统:精髓与设计原理(中文第七版)课本资料(Operating System: Essence and Design Principles (Chinese 7th Edition))
PILE
- 粘土中的垂直和水平荷载桩通过有限差分软件实现(Vertically and horizontally loaded pile in clay)
利用SURFER建立滑坡FLAC3D模型源程序
- 利用SURFER建立滑坡FLAC3D模型源程序(Establishment of FLAC3D Model Source Program for Landslide Using SURFER)
Goaf of Coal mine
- FLAC3D 煤矿采空区命令流用,FLAC 3D 模拟煤矿垮落法和充填开采影响的命令流。-(Command Flow in Goaf of FLAC3D Coal Mine .With FLAC3D simulation of coal caving method and the impact of mining backfill command stream.)
16apsk
- 16apsk信噪比与误码率的关系曲线 星座图(Constellation diagram of the relationship between signal-to-noise ratio (SNR) and bit error rate (BER) of 16APSK)
APDL成形程序
- 激光熔覆数值仿真温度场的计算,光内送粉形式的激光熔覆(Numerical simulation of laser cladding)
xc8_2.0_2.1破解
- 针对mplab ide的c编译器 xc8 版本v2.0 v2.1 破解文件 亲测好用 解压 按照对应的路径进行覆盖即可(C compiler xc8 version V2.0 v2.1 for MPLAB ide can crack files and overwrite them with decompression according to the corresponding path.)
ProjectH
- 3个绕组分段式永磁直线电机的模型,ansoft,maxwell的仿真文件,具体电机的参数可参看仿真文件。注意:要用18及以上的版本才可以打开(The model of three winding piecewise permanent magnet linear motors, the simulation files of Ansoft and maxwell, can refer to the simulation files for the specific motor parameter