资源列表
5层
- 我自己使用的一个五层混凝土MCNP中子屏蔽模型，具体分析如何减方差操作，包括自己写的心得(I used a five layer concrete MCNP neutron shielding model, specifically analyzed how to reduce variance operation, including my own experience)
变形光学表面的Zernike多项式提取
- 变形光学表面的Zernike多项式提取；光学镜面会在重力作用下发生形变。Zernike多项式用于拟合变形后的镜面。(Zernike Polynomial extraction of deformed optical surface.The optical mirror will deform under the action of gravity. Zernike polynomials are used to fit the deformed mirror surface.)
TopOpt-MMA-Python-master
- 采用python语言编写拓扑优化程序，考虑采用MMA(Using Python language to write topology optimization program, considering the use of MMA)
juli_tuoyin_jifeng
- 用matlba实现拖引干扰的程序，雷达欺骗式干扰。(Using MATLAB to realize the program of towed jamming, radar deception jamming.)
两轴高级轨迹规划PVT
- 基于运动控制器的PVT运动控制设置，用于多轴运动控制规划(PVT motion control setup based on motion controller is used for multi axis motion control planning)
fifomap
- c++ 顺序关联容器 很好用,可以代替map容器
VIENNARectifierTA_Three_Phase
- 三相整流器psim仿真VIENNARectifierTA_Three_Phase(Three-phase rectifier psim simulation VIENNARectifierTA_Three_Phase)
4-20mA XTR111正式版
- STM32 硬件PCB 图纸 输出4-20MA电流信号 采集频率信号(STM32 hardware PCB drawing outputs 4-20mA current signal and collects frequency signal)
slipBERI-master
- slipBERI是一个基于matlab的滑动分布反演程序，它利用大地测量数据（InSAR/GNSS）求解地震滑动。(slipBERI is a matlab slip inversion code, that uses geodetic data (InSAR/GNSS) to solve for earthquake slip at depth in a Bayesian sense. The primary purpose of this function is to incorporate
MT6261_GC6153_Driver_V0.2010.110
- 格科微GC6153模组驱动代码，QVGA，SPI接口，240*320(Gc6153 module driver code, QVGA, SPI interface, 240 * 320)
ST LINK驱动及教程
- 这是关与电机驱动的代码程序解释，设计了stm32的电路连线，以及外设的使用(This is explained by code program driven by motor, designed stm 32 circuit connection, and use of peripherals)
DYNA3D Code Practices and Developments
- dyna3d code应用及开发手册，非常稀有。(DYNA3D development manual, very rare.)