资源列表
globalvar
- linux 下的驱动编程 在pc机上实现的 调试完全OK-linux device drivers
TQ2440-640-480-linux-ov9650
- 在天嵌2440的开发板上能够用群创的7寸液晶800*480上显示640*480的OV9650摄像头图像的驱动和程序，注意，其他开发板不一定能用，下载之后，直接insmod ov9650-640.ko，然后运行camera_test640就可以了，附带代码。-the application program and device drive for ov9650 CMOS camera. the code is using for TQ2440 develepment board only.
gcc-4.1.2-RPM-Packeges-rhel-5
- rhel-5.1 GCC安装包 RPM格式-rhel-5.1 gcc packeges rpm
guoqiande
- 国嵌的所有视频实验代码，包括ads和linux的所有代码！-all of teaching of guoqian,include ads and linux!
lcd_frv400
- 富士通 FRV400 平台上的LCD测试程序-LCD Test program on FRV400 platform
spk_frv400
- 富士通 FRV400 平台上的扬声器测试程序-Speaker Test Program for FRV400 platform
sw_led_frv400
- 富士通 FRV400平台上的按键和LED测试程序-Keypad and LED Test Program for FRV400 platform
USBD
- 本书详细讲解了usb驱动的开发过程，可以帮助学习usb驱动-this is a book about learn usb driver
busybox-rx
- s3c2440 rootfile system busybox rx command source code.
serial_programming-kingseft-manulsan
- serial_programming-kingseft-manulsan.zip is linux termios programming source code.
CAN_MCP2515
- 该程序为基于s3c2440的CAN控制芯片MCP2515的裸机演示程序（其中已包含spi总线驱动）-The program is based on the the s3c2440 bare metal of the MCP2515 CAN controller chip demo program (which contain spi bus driver)
Sig_SW
- 本程序基于s3c2440的IO口电平状态检测驱动，适用于开关量信号检测电路。程序实现：检测当前IO口状态并通过串口打印。-This procedure applies to the switch signal detection circuit based on the the s3c2440 IO port level of state detection driver,. Program: detection of IO port status and print through the s