资源列表
2intauart
- LPC2000 中断和串口程序，ARM开启两个中断源Eint1与Eint2，分别用一个按钮来控制。在没有中断的时候两个LED都缓慢闪烁，当任何一个中断被出发的时候，对应的LED会急促闪烁，逐渐回复正常。 此外，使用一个串口来发送当前状态，在无中断的时候发送正常状态报告，当有中断的时候，串口发送中断源。 -lpc2000 interrupt and uart proc，tow interrupt resorces and seperately control tow led2 and se
virtualnetdevice
- 网卡DM9000驱动，linux环境，C语言-DM9000 network card driver, linux environment, C language
sim.c
- 通过adpu指令读取sim卡id号，其中包括串口通讯，adpu指令发送-read sim card s id number by adpu points，it includes serialport commnucation and adpu info
build
- THE MOST IMPORTANT FILE IN THE SYSTEM
tol_reset
- linux insmod可用的读取GPIO的驱动程序-linux driver for control gpio use insmod
serial
- Linux 下串口发收AT命令工具，下发后自动读取AT命令返回情况-Under Linux port to send and receive AT command tool, automatically reads AT commands issued after the return to the situation
nand
- linux 下的bootloader中的nand的裸板驱动程序-the driver of nand of bootloader
lpl_stepper
- linux下基于S3C2440开发的步进电机驱动，一根信号线控制HB202M细分器即可实现步进电机速度和方向的控制-linux based S3C2440 development of stepper motor drive, a signal line control HB202M subdivision stepper motor controller can achieve the control of speed and direction
RebuildImports
- The IDA Pro Book - Rebuild Process Import Table Example Copyright (C) 2008 Chris Eagle <cseagle@gmail.com> This program is free software you can redistribute it and/or modify it under the terms of the GNU General Public License as p
led
- 嵌入式设备驱动，对应mini2440，运用时makefile文件需要修改内核目录-Embedded device driver corresponding mini2440
s3c6410_leds
- 基于S3C6410的一个LED的驱动程序-S3C6410 an LED driver
beep.tar
- CW210开发板上的蜂鸣器控制,通过管脚复用来达到蜂鸣器的控制- Buzzer control CW210 development board through pin multiplexing to achieve buzzer control