资源列表
signa5
- 这段程序是相干光通信系统的仿真机，可以用matlab来仿真相干光通信系统，具体的参数可以在代码里面自行修改。(This program is a simulation machine for coherent optical communication systems. Matlab can be used to simulate a coherent optical communication system. The specific parameters can be modified in
STM32F103RE
- 基于canfestival的canopen主站移植(canfestival canopen master slave)
array_ant_yichuan_no problem
- 使用遗传算法优化了阵列天线方向图，亲自打的代码，已验证可使用(Genetic algorithm is used to optimize the pattern of the antenna array, and the code has been verified to be available.)
TransS7PPI V31
- PLC通讯组件,TransS7PPI V31(PLC,Trans S7 PPI V31)
Matlab_TracePro
- matlab与tracepro通信接口文件(Working with Matlab and TracePro through Dynamic Data Exchange)
OFDM(16qam和qpsk调制）
- OFDM调制发射和接收仿真，考虑两种调制方式，16qam及qpsk调制，使用LS信道估计和频域均衡(OFDM modulation transmission and reception simulation, considering two modulation modes, 16QAM and QPSK modulation, using LS channel estimation and frequency domain equalization.)
Cognitive Radio matlab code
- 最基础的检测概率；虚警概率；漏检概率与门限的关系。(Energy detection;Single threshold.)
hilbert
- 产生正弦信号时域波形及频谱，并通过希尔伯特滤波器。其中希尔伯特滤波器有两种产生方式，一是使用MATLAB自带的FDAtool；二是程序编写。(The time-domain waveform and spectrum of sinusoidal signal are generated and passed through Hilbert filter. There are two ways to generate Hilbert filter, one is to use FDAtool in
PCM编码解码matlab 代码
- PCM编码译码的matlab代码，设一个输入量，对其进行通信原理仿真。(The MAT code of the PCM code decoding, set an input quantity, and simulate the communication principle.)
PCM
- 在实际的调谐解调电路中，采用的是非相干载波解调，本振信号与发射端的载波信号存在频率偏差和相位抖动，因而解调出来的模拟I、Q基带信号是带有载波误差的信号。这样的模拟基带信号即使采用定时准确的时钟进行取样判决，得到的数字信号也不是原来发射端的调制信号，误差的积累将导致抽样判决后的误码率增大，因此数字QPSK解调电路要对载波误差进行补偿，减少非相干载波解调带来的影响。(In the actual tuning and demodulating circuit, non-coherent carrier
mmWave_Channel_Model-master
- 使用matlab进行毫米波信道模型仿真，很棒的源码(Millimeter-wave channel model simulation using matlab, great source code)
LDPC_codes-master
- ldpc编解码算法，c++实现，产生校验矩阵(LDPC Encoding and decoding algorithm, C + + implementation, generation of check matrix)