资源列表
CS-Channel Estimation
- 包括基于OMP算法的信道估计，以及LS信道估计等，比较不错(which includes OMP channel_estimate and other codes)
基于机动目标跟踪课题的整个算法程序
- 和雷达项目相关的目标跟踪程序，，很实用，有心人可以参考(And radar project related target tracking program, very practical, people can refer to)
三相表
- 国网三相表程序，可适用于振中900系列掌机使用，抄表清零可用。(In the three-phase meter procedures can be applied to the 900 series of handheld meter reading using vibration, can be cleared.)
TurboEqualization
- 经过验证，很好用的turbo均衡代码 经典(After verification, very good use of Turbo balanced code classic)
IQ_demodulation.m
- IQ正交采样处理，对实信号进行数字正交解调。一般用于雷达，通信前端。(IQ modulation is the data is divided into two, respectively, carrier modulation, two carriers orthogonal to each other. I: in-phase, q: quadrature .)
CRC16
- 在Matlab环境下用于计算CRC16的代码，本原多项式为X16+X15+X2+1，并提供测试文件。(In the Matlab environment for the calculation of CRC16 code, the primitive polynomial is X16+X15+X2+1, and provide the test file.)
neighbor discovery
- opnet 自编邻居发现，ad hoc自组网邻居发现方法(opnet neighbor discovery)
qq
- 频率位96--960MHz发射模块的程序，用于pocsag码发送(The program of the frequency bit 96--960MHz transmitting module for the transmission of the POCSAG code)
CA_CFAR
- 仿真了恒虚警的平均单元算法，给出仿真结果，同时分析了不同窗口数对虚警率和检测率的影响，并写了详细的注释(The constant false alarm average cell algorithm is simulated, and the simulation results are given. Meanwhile, the influence of different window numbers on false alarm rate and detection rate is ana
uPP_A_Receive
- dsp 实现upp数据通信功能,采用CCS5.5编写,可以作为大家学习的参考,非常有用(DSP Implementation of UPP data communication function)
MODBUS
- MODBUS协议及freemodbus的实现源码。适合应用于单片机/arm与触摸屏或者其他工控设备的通讯（绝大多数触摸屏都支持modbus协议）。(The MODBUS protocol and the source code for the implementation of freemodbus. It is suitable for the communication between single chip /arm and touch screen or other industrial
51单片机rc522 射频的程序和与电路图
- 完整的射频门禁程序源码包含rc522的驱动程序以及相应的显示程序(There had been many cases about RFID-based access control systems. In this paper, long-distance radio frequency technology was used and image-recognition technology was joined, these technologies were used to realize