资源列表
AddNoise
- Add noise in the system and then remove it through filters
jojo
- getting matlab source codes
LTE-SDR-Tx-Rx-Files
- Long term evolution transmitter and receiver end
ExampleCode_DDS_AD9914
- DDS芯片AD9914编程,产生单音信号,双音信号以及调幅调相信号。 -AD9914 DDS chip programming, generating tone signal, dual tone signal, and the amplitude and phase signals.
802.11n-BER
- The main goal of this project is to design and simulate a wireless communication system base on the IEEE 802.11n. A system was built and simulated in Matlab to obtain numerical result such as bit error rate plots and verify the functionality of
beamforming-using-convex-optimization
- The goal of this thesis is to use convex optimization for a beamformer. By using convex optimization we observed the signal in desired direction and also reduced the error in the stopband regions for Least-square norm and Innity norm. The simula
Chromatogram-baseline-estimation-and-denoising-us
- This a MATLAB software package Chromatogram baseline estimation and denoising using sparsity (BEADS) beads.m: Implementation of BEADS example.m: Baseline correction of a noisy chromatogram-This is a MATLAB software package Chromatogram baseline e
Alamouti-Encoder
- library IEEE use IEEE.STD_LOGIC_1164.ALL use IEEE.STD_LOGIC_ARITH.ALL use IEEE.STD_LOGIC_UNSIGNED.ALL use ieee.numeric_std.all
bpsk
- The code is about bpsk modulation. Signal is generated and modulated by BPSK before it sends to receiver.
SLM_And_Clipping
- SLM与削峰联合算法,matlab脚本文件-Joint algorithm of SLM and clipping
sparse-channel-estimation-algorithm
- 基于多输入多输出的正交频分复用的压缩感知稀疏信道的估计算法-An estimation algorithm for compressed sensing sparse channel based on multiple input multiple output orthogonal frequency division multiplexing
transmitter-locate
- Locate a transmitter using adults in polar coordinates Where the two adult coordinates are used and through the program the location of the transmitter is determined