资源列表
Phone-AT-commands-
- 手机ＡＴ指令，用于控制ＧＳＭ模块收发短信，语音通信等操作的代码说明-Phone AT commands used to control the GSM module to send and receive text messages, voice communications, the operation code shows
i2c_master
- 一个好用的I2C接口master的verilog程序。
111111111
- 各种模拟调制和数字调制的波形和频谱图，对初学者很有帮助-A variety of analog modulation and digital modulation waveform and frequency spectrum
ForcingZero_LMS_EQ
- 采用迫零均衡算法和LMS(最小均方误差)算法，实现Matlab下信道均衡的仿真-Forcing Zero/LMS in equilibria simulation using Matlab
eetop.cn_Uart
- 实现串口硬件接收，有一个接收程序，分频程序-Serial hardware receiver, a receiving process, frequency program
uwbppm
- 经PPM调制的超宽带信号经高斯白噪声信道的系统仿真,给出了时域和频域图-After the PPM modulation ultra-wide band signal after the Gauss white noise channel system simulation,and give the time domain and the frequency range chart!
main_program
- matlab program for cognitive radio development
GPSPOSITION
- GPS 实验,定位位置并给出坐标转换方式-GPS experiment, positioning location and gives the coordinate transformation
cupcake
- 详尽描述Android1.5版本cupcake的编译步骤，按照此步骤能顺利编译通过（windows或linux）Android的源码。编译环境：VMware Workstation5中装ubuntu 8.10
PC-and-intelligent
- 6．3 PC机与智能仪器串口通信 在vb环境下进行串口调试 -6.3 PC and intelligent instrument serial interface communication
dianji
- cw程序MCP文件,用于电机驱动程序，用于飞思卡尔mc9sxf512单片机-cw MCP program files, for motor drivers for Freescale microcontrollers mc9sxf512
WCDMAjiaozhi
- 用于WCDMA的交织编解码部分，是实用的WCDMA系统的交织程序。-WCDMA for the intertwining of the codec part of the practical WCDMA system intertwined procedures.