资源列表
RDSigGen
- 北斗一代信号源RTL源代码，可以生产RDSS中频数字信号。-RTL source code for BD1 signal.
GPS_single_point
- 用于gps单点定位的matlab程序，通过读取.O和.N文件进行定位-For single point positioning gps matlab program to locate files by reading .O and .N
Simulation_tracking
- EKF Filter for Tracking
M_CA_CODE
- GPS的CA码产生与验证,从最原始的m序列开始分析，最后有相关与互先关对比分析。-GPS CA-code generation and verification
read_SP3
- 本程序用于读取GPS中精密星历SP3文件，得到各个卫星的坐标序列-read the sp3 file of GPS
GPS
- 程序包用于读取GPS观测文件，广播星历文件，以及生成单差，双差，三差虚拟观测值-read the rinex file of GPS,and get the singleDelta,doubleDelta,threeDelta
GPStoUTC
- 基于ARM7平台开发的GPS数据接收并提取UTC等关键信息，同时通过LCD驱动显示-Based on ARM7 platform, the development of GPS data receiving and extracting UTC and other key information, and through the LCD driver display.
GPS_Message
- STM32开发平台下GPS的信息获取代码， 并通过LCD128液晶屏，使用并行显示方式将信息显示出-The GPS information access code under the STM32 development platform, and through the LCD128 LCD screen, using the parallel display mode to display information
baiduMap_OFFset
- asp开发的，带百度地图纠偏数据库，可以连续取百度地图上的点，显示纠偏后的经纬度（原始坐标）-asp development, with Baidu map correction , you can continuously take point on the map Baidu, show the latitude and longitude correction after the (original coordinate)
PMF-FFT-GPS
- GPS 捕获跟踪程序，用的是PMF-FFT捕获方法。门限设置为0-GPS capture and tracking procedures, using the PMF-FFT capture method. Threshold set to 0
GPS
- 利用Arduino获取GPS串口信息，从信息串中截取时间、经纬度信息，并将信息转换格式后通过串口发送并显示-Get use Arduino serial GPS information, the interception time, latitude and longitude information the burst, and the information is sent through the serial port after format conversion and displa
compass_frontend
- 北斗接收机的射频前端信号处理，非常有借鉴价值-Beidou receiver RF front-end signal processing, the very reference value