资源列表
TAPI
- this a c code for the development of TAP protocol application-this is a c code for the development of TAP protocol application
final-GPS
- GPS信号捕获跟踪的MATLAB仿真里面有文档说明。-GPS signal tracking capture of MATLAB simulation there is documentation.
U220ModeProtocol
- U220-模块协议规范 北斗定位模块 对与GPS+BD开发者有参考价值。-U220- module protocol specification BD module
Telit_USB_Driver_Win
- moto/tilt c24通讯模块的USB驱动程序,用于直接通过USB访问C24 -moto/tilt c24,with it can directly access the module by USB PORT
gnss-sdr.tar
- GNASS SDR软方案源代码，开源的代码，学习GNASS非常有用。-gnass sdr solution
n490_boot
- Navon n490 ROM board bversion LH43FIPA5_Ver5.3 2011.03.31
ComputStarPosition
- 根据GPS卫星的广播星历，计算卫星的位置，也可以进行GPS卫星位置的预报-GPS satellite broadcasting ephemeris, the location of the satellites, will be able to conduct the GPS satellite location prediction
work
- GPS软件接收程序，包括捕获，跟踪和定位解算。捕获采用并行码相位捕获算法。-GPS software receiver, including capture, tracking and positioning solution. The acquisition uses a parallel code phase acquisition algorithm.
NMEA-0183parser
- NMEA-0183解码，支持GGA、GLL、GSA、GSV、RCM、VTG、ZDA。 可解析多类型数据，也可以解析单一类型数据，输出结果建议使用UltraEdit查看-NMEA-0183 decoder that supports GGA, GLL, GSA, GSV, RCM, VTG, ZDA. Can resolve many types of data to be parsed single type of data, the output is recommended to use U
signal_code_gen
- 基于Matlab产生并仿真GPS模拟信号，代码经过调试，亲测可用-Based on Matlab and simulate GPS analog signals generated code after debugging, pro-test available
GPS-DAQ
- GPS串口采集程序，基于VC++ MFC，非常不错的资源，采用多线程实现。-GPS serial acquisition program, based VC++ MFC, very good resources, using multithreading.
tdoa
- 基于matlab的室内定位算法。tdoa算法，matlab算法，-Indoor positioning algorithm based on matlab. TDOA algorithm, matlab algorithm,