资源列表
TRANF
- RTK实时相位测量 坐标变换子程序 RTK初步程序设计-Real-time RTK RTK phase measurement coordinate transformation routines preliminary program design
CP0902
- 用matlab实现的超宽带物理层的仿真 。-Using matlab to achieve the ultra-wideband physical layer simulation.
GPSdenoise
- GPS单历元信号变形监测数据去噪处理。包括小波软/硬阀值去澡,中值滤波去噪-Single epoch GPS deformation monitoring data signal de-noising processing. Including wavelet soft/hardware to the shower threshold, median filter denoising
lambda2
- GPS 整周模糊度解算 程序 MATLAB语言 LAMBDA算法-GPS anbiguity matlab
GPS
- 利用Arduino获取GPS串口信息,从信息串中截取时间、经纬度信息,并将信息转换格式后通过串口发送并显示-Get use Arduino serial GPS information, the interception time, latitude and longitude information the burst, and the information is sent through the serial port after format conversion and displa
fcm1
- function [U,V,num_it]=fcm(U0,X) % MATLAB (Version 4.1) Source Code (Routine fcm was written by Richard J. % Hathaway on June 21, 1994.) The fuzzification constant % m = 2, and the stopping criterion for successive partitions is epsi
lambda
- GPS 模糊度解算程序 Matlb语言 RTK-GPS ambiguity matlab rtk
Cal-of-Correlation-Coefficient
- 阵列天线单元间,接收信号功率谱高斯时,分布互相关系数计算-The calculation of correlation coefficient between two units of the antenna array when the receiving singals power spectrum fits the Gaussian distribution.
stap
- 基于Matlab仿真了全自由度空时自适应处理算法,并画出相应的结果图-Matlab simulation of a full degree of freedom based on space-time adaptive processing algorithms, and draw the corresponding results of Figure
signal_gener
- 用于产生模拟GPS天线前端接收到的中频信号,暂时未加噪声,如有需要,可自行添加。其中关于C/A码产生的函数-Used to generate simulated GPS antenna front-end receiver to the IF signal, plus noise, if necessary, can add their own.
pseudorange
- 该程序是对GPS接收机输出的原始数据(indata.log文件)进行分析计算-procedures for the GPS receiver output of the original data (indata.log) for analysis
tcl.tar
- using this file evaluate tcp performance