资源列表
arrayantennacode
- 这是阵列天线中的仿真代码,可以作为卫星接收中阵列天线仿真的参考。-This is the array antenna simulation code.
wssus_simulink
- 仿真了WSSUS信道的调相仿真模型,通过此模块,可以观察信号在传输过程中产生的多径效应和衰落情况。-WSSUS channel simulation of the PM simulation model, the passage of this modules, can be observed in the transmission signal generated by multi-path effects and the decline of the situation.
qqxiey
- 易语言 QQ最新手机协议 批量登陆 消息接收-Easy language batch landing QQ latest phones protocol message reception
Huawei-Modem-Unlockerv5.8.1
- huawei unlock tool v.5.8.1
arrayantennacode4
- 这是阵列天线的仿真代码,可以用在卫星通信和移动通信中作参考。-This is the array antenna matlab code.
OFDM-simulation-and-analysis.r
- 1.通过对典型环境下OFDM系统参数的设置,获得了OFDM性能参数的描绘和优势。 2.对OFDM系统下的误码率进行了数值仿真分析,给出了误比特变化区间。 3.代码风格良好,结构严谨,注视充分,适合接口移植和修改。 ,1. Through a typical environment, OFDM system parameters set to obtain the performance parameters of the OFDM descr iption and advantages.
New-folder
- image in mimo ofdm in transmission in receiver side
WIMAX_Turbo_Code
- 这是一套完整的支持wimax 16e协议CTC的编译码程序, 主程序在demo.c 译码器:tcdecoder.c 编码器:tcencoder.c-/* This program simulates the classical turbo encoding-decoding system on PC.*/ /* It uses parallel concatenated convolutional codes described in Figure 2.9 in Chapter
LDPC
- 无论是那种编码方式,在AWGN信道中的性能都明显由于在瑞利衰减信道中的性能。这一点也符合实际。毕竟AWGN信道是瑞利衰减信道的特殊情况。除此之外,在研究单一编码方式误码率时,样本帧数越大,则得到的误码率曲线就越平滑,较少出现较明显的凸起。(Either way, the performance in AWGN channel is obviously due to the performance in Rayleigh attenuation channel. This is also in l
st7_i2cslave
- st7单片机关于slave方式I2C总线设计的源程序,使用ST7单片机的很有用-st7 microcontroller on the slave mode I2C bus design of the source, use ST7 MCU useful
802.11a-OFDM
- 基于matlab的OFDM仿真程序; 我再论坛找了很多OFDM的代码和文章,但总有遗患,为什么呢原因是大部分只有简单的映射,IDFTDFT变换等等,但主要的同步和信道估计去没有人提出来,甚至做出来.. 现在我终于找到了一份,它以FUNCTION的形式,再现了OFDM映射,IDFTDFT,同步(时间频率同步)和信道估计,以及频率偏移的估计等一系列代码.-Based on the OFDM matlab simulation program I' ll find a lot o
simulator
- 有很多源程序,可供OFDM编程使用~16QAM,64qam-There are many source for the use of OFDM Programming ~ 16QAM, 64qam, etc.