资源列表
channel
- fo communication eng
VBLAST
- In this simulation, a 2 x 2 MIMO system with BPSK modulation is used. Then, the algorithm of V-BLAST is implemented. After that, weight vector is produced using ZF, MMSE and ML detectors. Finally, the BER performance is plotted. A flat fading Rayleig
tx_power_amplifier
- 通信系统中功率放大器实现的MATLAB代码,对于OFDM研究新手很有参考意义-power_amplifier method in OFDM system
zhao_srsk_honig
- users and link gains generation FIXED POWER FOR EACH SU LINK NO POWER CONTROL FOR SUs WITH ON OFF activity for PUs and SUs d_00=start of franhaufer zone d_0=radius of cell, d_su=radius of pairwise adhoc N/W - users and link gains genera
L_3
- 多用户检测算法中的patsd子空间跟踪算法,用户数为4-Multi-user detection algorithm patsd subspace tracking algorithm, the number of users for the four
Pss_detect
- LTE中同步信号的检测程序,根据matlab语言编写,用来检测主(辅)同步信号-LTE synchronization signal detection procedures, according to matlab language used to detect the primary (secondary) synchronization signal
CHF
- 设定无线接入点能够始终提供最大吞吐量,终端节点的冗余通信模块各自的网络信道信噪比值随机变化,由此计算得冗余网络各自的CHF值。CHF切换机制根据冗余网络各自的采样值大小进行切换判决,考虑门限的CHF切换机制根据设定的上下切换门限值进行切换判决
MotePacket
- 在Mote节点与主机实现互联的前提下,完成数据报的发送-Mote nodes and hosts in the Internet under the prerequisite of the realization of complete data reported Send
fft
- FFT 函数实现,可在C C++环境下编译,辅助信道方面的计算,也可运用到工程计算-FFT functions, and can be compiled in C C++ environment, aspects of computing auxiliary channel can also be applied to engineering calculations
ofdm
- ofdm系统的基础结构,采用4QAM编码解码,并采用FFT/IFFT运算,最终计算误码率.-Ofdm system infrastructure, using 4QAM codec, using FFT/IFFT operations, the final calculation of the error rate.
MIMO-system
- 介绍MIMO系统的仿真方法。对初学者有一定的帮助。-introduce the way running mimo systerm,to help the leaner .
Series-to-parallel-in-matlab
- Matlab file for 3g MVDR for the channel estimation and others you can find more about MIMo ans siso system