资源列表
Monte-Carlo-simulation-analysis
- 投掷筛子6次,然后对投掷的一些参数进行分析,蒙特卡洛仿真分析-Monte Carlo simulation analysis
shaizi
- 分别用理论计算和计算机模拟计算,求连续掷两颗骰子,点数之和大于6且第一次掷出的点数大于第二次掷出点数的概率。-Were used to calculate the theoretical calculations and computer simulations, seeking continuous throwing two dice, and more than six points of the first throw and the number of points is greater
0505-8k0
- GSM specification Technical Specification 0505-8
SENSIM_v3.1
- OMNET++下SENSIM仿真代码,C++代码实现的基于OMNET++下的仿真-OMNET++ under SENSIM simulation code, C++ code OMNET++-based simulation
SUAproto
- SUA协议模块实现源码,可运行于linux/嵌入式操作系统平台,接口标准。-SUA protocol module source code can be run on linux/embedded operating system platform interface standards.
3GPP_Tutorials_01_Layer1_General_Description
- This an internal tutorial material from one european company. this document is about the physical layer. I will continue to upload all the training material.-This is an internal tutorial material from one european company. this document is about the
Autostart
- 该工具用于使用MAXII CPLD实现了Target I2C功能,例程很全,包括Modelsim仿真
lte-adv-to-3gpp
- A document submitted to 3gpp for the standardisation of the fourth generation standard of mobile communication
AT_Command_Set_Gobi
- This document specifies the AT command set for Gobi™ . It groups AT commands into several categories. Each category identifies all AT commands applicable to that category, specifies supported targets, and describes the applicable mode.
ns2-802.15.4-code-explanation
- ns2 802.15.4 code explanation 802.15.4的ns2仿真程序,可以参考-ns2 802.15.4 code explanation 802.15.4 ns2 simulation program, you can refer to
ImageProcessing
- image processing with MATLAB
wpan_zbr
- ns2 802.15.4 源码 和相关说明-ns2 802.15.4 source code and related instructions