资源列表
HD7279DISP
- 一个利用hd7279dsp的温度报警器，可以实现实时的测量温度，温度超过一定设定即会触发蜂鸣器和报警灯。-Hd7279dsp use a temperature alarm, can achieve real-time measurement of temperature, the temperature exceeds a certain set will trigger a buzzer and warning lights.
web-http-STM32-W5100
- stm32的w5100，http实现。使用w5100模块，实现单片机的网络接入。-W5100 STM32, HTTP implementation.
inverter-SPWM
- STM32单片机主控器，推挽全桥逆变器，SPWM控制，查找表生成SPWM波形，闭环，输出220V/50Hz交流电-STM32 microcontroller master, push-pull full-bridge inverter, SPWM control, look for 220V/50Hz AC table generating SPWM waveform, the closed-loop output
BDC
- 双向DC/DC变换器程序，数字恒流源输出电流步进可调，采用STC单片机作为主控器-Bi-directional DC/DC converter program, digital adjustable constant current source output current step, using STC microcontroller as master
c
- 此为单片机编程系列源码，采用C语言编写,包括PWM.AD转换，12864LCD等。- T This is a single-chip programming source code, using the C language, including PWM.AD conversion, 12864LCD.
AMaDSB
- 该C语言例程为AM波，DSB波调幅程序，适用于单片机等等。-The C language routines for the AM wave, DSB wave amplitude modulation procedures, for single-chip and so on.
CAR
- 该例程实现嵌入式开发板视频传送功能，采用C语言编写。-The routines to achieve embedded development board video transmission function, using the C language.
dianzicheng
- 20Kg电子秤开发板配套程序，测量精度高、范围广，该例程为C语言程序。-20Kg electronic scale development board supporting procedures, high accuracy, a wide range of routines for the C language program.
FLASH_
- flash的读写控制最终判断读写是否一致可用LED显示，构建基本模块-flash read and write control of the final judgment is consistent read LED display is available to build the basic module
source_code
- 应用于可见光中的OOK调制，传1的时候传送一个周期正弦波，发0的时候传送1- Applied to the visible light in the OOK modulation, the transmission of a period of 1 times a sine wave, 0 of the time to send 1
60
- 利用实验板实现模六十计数，即00—01—02—03—04—…59—00—01…，并在Basys2实验板的AN1~AN0与（LD7~LD0）上显示-Experimental plate to achieve mode 60 counts, namely 00-01-02-03-04- ... 59-00-01 ... AN1 ~ AN0 Basys2 experiment board with
counter60
- 基于FPGA的模60计数器，实现0-59计数，四个数码管后两个显示十位和个位，拨盘按钮P11为复位键。-FPGA-based mold 60 counters to achieve 0-59 counts, two of the four digital tube display after ten and a bit, dial button P11 for the reset button.