资源列表
SCH_51_E
- 采用32位单片机控制BOost电路升压,此电路为主控回路,非常有用!-32-bit single-chip control BOost circuit boost, the circuit for the main control loop, very useful!
uart_test_main
- Linux下的uart测试,验证串口通路是否正常。-Uart test under Linux, validation of serial circuit is normal.
stm32_UCOS-II
- ucos 移植于STM32,并成工运行。 -ucos 移植于STM32
code
- vhdl code which includes various codes of clock divider uart lcd etc
ultrasonic
- 本程序是在STM32F103ZET6单片机的定时器输入捕获功能实现超声波模块的调试-This program is an input capture function in timer STM32F103ZET6 single-chip debug module to achieve ultrasonic
SG90
- 程序是基于STM32F103ZET6实现舵机调试,源码可以实现用户给指定角度,然后舵机转到相应角度-Procedure is based servo STM32F103ZET6 achieve debugging, source code may be implemented for the user to specify the angle, and steering angle corresponding to
TIM_NVIC
- 基于STM32F103ZET6实现定时器中断实现定时器中断功能-STM32F103ZET6 achieve timer interrupt based timer interrupt function to achieve
SPI_sent_rec
- 基于STM32F103ZET6单片机实现SPI通讯协议的接收以及发送数据-Receiving and transmitting data STM32F103ZET6 MCU SPI communication protocol based on
pwm_check
- 基于STM32ZET6单片机实现定时器的pwm输出功能并连接小灯实现呼吸灯功能-Based STM32ZET6 MCU timer pwm output and connect small light lamp function to achieve respiratory
MPU6050_check
- 在stm32单片机上利用IIC通讯协议实现mpu6050陀螺仪工作,利用上位机观察陀螺仪的位置情况-IIC communication protocol using the MCU mpu6050 stm32 gyroscope work, using the position where the PC observed gyroscope
yaoyaobangchengxu
- 基于stc89s52写的摇摇棒程序,通过led的动态显示出各种图案-Based on stc89s52 write shake stick procedures, led by the dynamic display of a variety of patterns
PX4bootloader
- Pixhawk 的bootloader文件,共四个文件px4fmuv2_bl.bin,px4fmuv2_bl.elf,px4io_bl.bin,px4io_bl.elf-bootloader for pixhawk or PX4