资源列表
谱曲软件
- 一款很不错的利用PWM与蜂鸣器的谱曲软件(A very good use of PWM and buzzer Music software)
超声波测距（LCD1602显示）
- 利用超声波测距并于1602上显示的程序，很实用(The use of ultrasonic ranging and displayed on the 1602 program, very practical)
基于单片机的智能计算器
- 基于51单片机开发的智能计算器程序，包含科学计算器的几乎全部的功能(Based on 51 single-chip development of intelligent calculator program, including scientific calculator almost all of the functions)
ANDS3080
- 读取鼠标传感器采集到的位移速率，使用的硬件平台是stm32c8t6(Read the displacement rate collected by the mouse sensor)
EKBoard
- stm32f103开发板资料，以前使用的，可以测试通过(STM32F103 development board information, previously used, you can test through)
Nios2_LB0
- 利用Nios平台用C语言跑通LED循环点亮(Use the Nios platform to run the LED cycle with the C language)
DSP2812（PMSM）程序
- 使用tms320f2812dsp输出6路pwm驱动永磁同步电机，采用磁场定向矢量控制，简单高效(Using TMS320F2812DSP output 6 way PWM drive permanent magnet synchronous motor, using magnetic field oriented vector control, simple and efficient)
video_Algorithm
- 图像处理如：灰度化，二值化，中值滤波，边缘检测，直方图，哈夫变换等(for dsp video algorithm)
IIC
- 操作AT24C02代码，包括读，写，批量读和写等操作(Operation AT24C02 code, including reading, writing, batch reading and writing operations)
20141022 CAN收发
- STM32F107芯片的CAN的通讯程序，自收自发，中断接收(STM32F107 chip CAN communication program, since the spontaneous, interrupt reception)
gprs800
- SIM800开发调试程序,SIM800 GSM GPRS模块 开源驱动源码(SIM800 Development debugger)
RS485
- MODBUS 驱动源码，支持RTU ASCII通信，只需调动接口方便程序编写(MODBUS driver source code, support RTU ASCII communication, just transfer the interface to facilitate the preparation of the program)