资源列表
实验0 新建工程实验
- 寄存器版本例程,应用于新建工程,适合初学者使用(Register version routine)
6.温度传感器带蜂鸣器版
- 基于zigbee协议栈的温度传感器ds18b20应用，芯片为cc2530，当温度超过30度时，接在协调器上的蜂鸣器报警响起。(ZigBee protocol stack based on the temperature sensor DS18B20 applications, the chip is CC2530, when the temperature is more than 30 degrees, connected to the coordinator buzzer alarm sou
20121109_LEDrunningtime_v1
- 车用LED调光计时程序，根据时长计算LED模组的温升及发热情况PWM调整LED的亮度，并累计LED模组的使用寿命(The car LED light timing program, according to the length of the LED module temperature rise and heating condition PWM to adjust the brightness of the LED, and accumulated LED module's service
BMP280_driver-master
- 官网推荐的API，具备温度气压检测，官网算法(The API recommended by the website is equipped with temperature and air pressure detection)
step_motor_2
- 中断控制双路步进电机运转，正传，反转，（新手，结构不是很清晰，但是能用）(Interrupts control double - step motor running, forward, reverse, (novice, not very clear, but can be used))
Vacuum2-2KEY_2-4LED
- 按键控制真空泵运转，累计计时计次，一键清零，双路输出，定时长运行自动停止，7段码显示(The key controls the operation of the vacuum pump, the accumulative time is calculated, one key is zero, the double channel output, the regular long running automatic stop, 7 code display)
CPS
- PIC单片机电容触摸输入功能，LCD段码显示(PIC single chip capacitor touch input function, LCD segment code display)
F334 Buck-Boost VMC v1.0
- 基于STM32F334的buck boost程序设计(Design of buck boost program based on STM32F334)
ALIENTEK MINISTM32 实验8 PWM输出实验
- 基于STM32的pwm波的输出，控制led灯的亮度(STM32 based PWM wave output, to control the brightness of LED lights)
ALIENTEK MINISTM32 实验15 ADC实验
- 在STM32开发系统中对模拟信号和数字信号进行转换(In the STM32 development system, analog signals and digital signals are converted)
GPIO输入—按键检测
- stm32 库开发，工程模板GPIO输入—按键检测(STM32 library development, engineering templates, GPIO input - key detection)
ALIENTEK MINISTM32 实验11 TFT LCD液晶显示实验
- 在STM32开发系统中进行TFT液晶显示(In the STM32 development system, the TFT LCD display)