资源列表
STM8实现按键LED程序
- 实现stm8的IO口之间的互动，电路板上高低电平的转换，体现为按键和LED灯。 按下按键，灯亮。并且有流水灯功能。(Realize the interaction between the IO ports of stm8, the conversion of the high and low level on the circuit board, reflected as the key and the LED light. Press the button, the light is on
Project_RTI
- s12xep100 RTI模块简单的设置及波形生成。(s12xep100 RTI for pwm)
用单片机PWM实现DA
- 如果在单片机控制的仪表里用PWM方式完成D/A输出，将会使成本降低到12位D/A芯片的十分之一左右。我们在S系列流量仪表中采用了这种方式，使用效果非常理想。下面介绍一下PWM方式D/A的构成原理。(If in the microcontroller control instrument, using PWM way to complete the D/A output, will reduce the cost to 12 bit D/A chip about 1/10. We have ado
STC12C5A60S2单片机各个模块程序代码
- 这是关于stc12c5a60s2各个模块的程序(This is about each module of STC12C5A60S2 program)
he
- 利用VHDL实现判向计数器，并且在数码管上实现显示。可以在XILINX开发板上实现对应功能，仿真也能实现。(The use of VHDL realize the counter counter, and in the digital tube to achieve display. The corresponding function can be implemented on the XILINX development board, and the simulation can also
延时程序
- 延时程序，自己整理的一个延时程序集合，可以方便调用直接使用不需要计算(Delay procedures, finishing a collection of their own delay procedures, you can easily call the direct use, do not need to calculate)
实验13 TFTLCD显示实验
- LCD屏幕显示程序,测试LCD屏幕正常显示的程序(LCD screen display program, test the normal display of LCD screen program)
s12xep100 PWM
- xep100的PWM模块的实例，比较通用，可直接配置频率/占空比。(s12xep100 pwm,the frequency/proportion can be directly configured.)
TEST
- 4通道4-20mA模拟量采集板通过RS485总线发送采集数据给PC机(The 4 channel 4-20mA analog acquisition board transmits data to the PC through the RS485 bus)
newtest
- bios在F28377中的实现，bios程序和普通的程序的嵌套，包括TASK线程(BIOS in F28377 implementation, BIOS procedures and common procedures nested, including TASK threads)
MPU6050
- 读取陀螺仪数据并传到匿名非控上位机，可以读取曲线，姿态等数据(Read the gyro data and send it to an anonymous non controlling host computer to read data such as curves, gestures, etc.)
W25Q256
- w25q256驱动代码，包括读写函数等等。(w25q256 Driver. w25q256 is a SPI Flash. Including write function and read function,etc.)