资源列表
STM32F7ucosiii-任务挂起与恢复
- 将ucos-iii系统运行与stm32f7单片机上实现任务的挂起与恢复(Ucos-iii system operation and stm32f7 MCU to achieve the task of hanging up and recovery)
CRC
- MODBUS RTU协议的仪表通信时需要进行CRC校验，单片机可以用此程序生成CRC校验码，多项式是0xA001 所用单片机为STC15系列单片机，不过CRC生成过程很简单，通用的51单片机都可以生成(MODBUS RTU protocol instrument communication needs CRC verification, SCM can use this procedure to generate CRC checksum, the polynomial is 0xA001
stm32移植GRBL
- GRBL简单的说就是一款基于Arduino的开源雕刻机控制软件。可以解析标准G代码并控制相应的步进电机运动。 GRBL效率高，成本低，因此大部分DIY激光雕刻机和自制CNC都会使用GRBL作为主控程序。(GRBL, in brief, is a Arduino based open source engraving control software. You can parse the standard G code and control the stepper motor movement
zhengche
- 通过matlab/SIMULINK对整车进行建模，实现变速器具有更好的控制效果(The vehicle is modeled by MATLAB / Simulink, and the transmission has better control effect)
gc308 zc
- stm32 gc308 摄像头 程序 IIC(stm32 gc308 camera IIC)
基于51的智能火灾报警系统设计 LCD1602显示
- 基于51的智能火灾报警系统设计，以 LCD1602显示。(Based on 51 intelligent fire alarm system design, to LCD1602 display.)
STM32F7ucosiii-时间片转调度
- 在STM32F767单片机上运行ucos-iii系统实现同优先级的时间片转调度(Run the ucos-iii system on the STM32F767 MCU to realize the scheduling of the same priority time slice)
mg182
- There is a well attenuation curve as input to calculate its seismic waves, Including the final calculation of the compressed image peak signal to noise ratio and compression of the source, Achieve serial data acquisition.
DigitalFrequencyMeter
- 使用Basys3开发板，采用等精度测频方法实现信号的测频并通过LCD1602显示。(The use of Basys3 development board, the use of equal precision frequency measurement method to achieve signal frequency measurement, and through the LCD1602 display.)
fft0
- CCS软件平台中的DDR EIMA 外设操作(DDR EIMA peripheral operation in CCS software platform)
fft1
- 在DSP情况下 并行优化方法下的优化实验(Optimization experiments under the DSP parallel optimization method)
fft2
- 在 DSPBIOS中多线程编程程序开发方法(Multithreaded programming program development method in DSPBIOS)