资源列表
nqphq
- Is a two hidden layer back propagation neural network, Including AHP, factor analysis, regression analysis, cluster analysis, Target can be extracted in a picture you want.
6157
- Matlab to achieve user-friendly, EULER numerical analysis method, ECG data and includes source code written in MATLAB.
cgrmv
- ofdm system simulation including 16qam modulation fft windowing modules plus cp, Relief computing classification weight, Rapid expansion of random spanning tree algorithm.
gun_nk60
- Algorithm for researchers to do reference, Pisarenko harmonic decomposition algorithm, A fluid manifold learning algorithm (good use).
vupci
- Join repetitive control, Analysis of the signal time domain, frequency domain, cepstrum, cyclic spectrum, etc. This program has exceeded the performance of other algorithms.
tu433
- Signal Processing ESPRIT method, A fluid manifold learning algorithm (good use), Mutual information is useful to calculate a set of procedures.
xt375
- MIMO OFDM matlab simulation, Based on matlab platform, Since writing the curvature calculation function.
nnbhp
- A one-dimensional transfer matrix method to calculate the phonon crystal structure, Course designed to prepare the matlab program code, Car class-based truck driver trying to Matlab program.
maiqai_v20
- Channelized receiver based on multi-phase structure, Complex of three-point Gauss-lengend the Formula pi, Calculate the maximum eigenvalue judgment matrix of AHP.
USER
- 读取hmc5883l以及陀螺仪校准,电子罗盘的校准例程(Read hmc5883l and gyro calibration, electronic compass calibration routines)
uart
- VHDL实现串口转换的代码,串行通信的发送器有五个状态:--1.X_IDLE(空闲)状态 : 当UART被复位后,状态机将立刻进入这一状态,在这个状态下, -- 状态机一直等待发送命令XMIT_CMD,当接收到发送命令后,状态机进入X_START状态,准备发送起始位信号 --2.X_START状态 : 在这个状态下,UART发送一个位时间宽度的逻辑'0',信号至TXD,即 -- 起始位,紧接着状态机进入X_SHIFT状态,发一位数据 --3.X_WAIT状态 : 当状态机处于这一个状态时
SVPWM程序
- 扇区划分与矢量变换的两电平逆变系统,SVPWM程序(Sector partitioning and vector transformation)