资源列表
HVPM_Enhanced_Sensorless
- 28035应用模板，包括端口初始化设置，里面包括采样，pwm，输入捕获，和 一些基本的控制(28035 application templates, including port initialization settings, which include sampling, PWM, input capture, and Some basic controls)
时钟程序(自带温度)
- 基于stm8s系列单片机的tm1620和74hc595芯片的操控(The manipulation of tm1620 and 74HC595 chip based on stm8s Series Singlechip)
Ir
- 基于fpga的红外通信，通过红外控制led灯(Infrared communication based on FPGA)
SystemVerilog断言及其应用
- 该书用来阐述如何使用断言，以及断言的语法和示例(The book is devoted to the use of assertions, as well as to the syntax and examples of assertions)
TS8900-M128开发板例程（AVR）
- TS8900-M128整套例程 C语言 可实现跑马灯 显示屏 按键 蜂鸣器实验(TS8900-M128 complete set of routines)
DA14580_DS_3v4
- 蓝牙、软件编程详细说明，希望能帮助到大家(Bluetooth, software programming detailed, and I hope to help you)
匿名领航者源码
- 飞控源码，适合新手开始学习飞行器，带有原理图，上位机，资料等(Ano, flight control, aircraft, four axis, four rotor, source code)
datasheet
- 可测试EMIF接口，包含读写两种时序,1394协议，LM75A(EMIF interface can be tested, including reading and writing two timing)
FT232_CBUS_source
- FT232_CBUS_source code
inputtest
- 本实验利用TIM5_CH1来做输入捕获，我们将捕获PA0上的高电平脉宽，并将脉宽时间通过串口打印出来，大家可以通过按WK_UP按键，模拟输入高电平。同时，本实验将保留上一个实验的PWM输出，DS0还是会由暗-->亮的循环变化，大家可以通过杜邦线连接PA0和PB5，来观测PWM输出的高电平时间。(This experiment uses TIM5_CH1 to do input capture, we will capture the PA0 high level pulse width,
IR_RS232
- 红外遥控代码,需要重新配置SysTick的中断优先级为最高，要不然SysTick延时中断抢占不了IO EXTI中断,或者当你用其他定时器做延时的时候，要配置定时器的优先级高于IO EXTI中断的优先级.(Reconfiguration of SysTick interrupts the highest priority, otherwise SysTick delay interrupts cannot preempt IO EXTI interrupts * because the defa
delay
- 此程序在于对arduino控制板的延时环节进行设置(This procedure is to set the Arduino control board delay link)