资源列表
Camera
- camera source jdlksahdlksa
ChaoShengBo2
- 利用超声波模块测距，并以此设计成汽车入库系统(The ultrasonic module is used to measure distance, and the vehicle storage system is designed.)
jieshou_over
- multisim仿真信号前置放大电路，可以对40mV电压信号进行三级放大(Multisim Simulation signal pre amplifier circuit can be used to amplify the 40mV voltage signal in three steps)
digital_photo_frame
- 基于s3c2440的数码相框 图片解码 libjpeg(Based on s3c2440 digital photo frame)
矩阵键盘
- 矩阵键盘，C语言，stc89c52的矩阵键盘程序(Matrix keyboard, C language, STC89C52 matrix keyboard program)
STM8S_内部EEPROM编程
- STM8S 单片机EEPROM 使用的例程(STM8S microcontroller EEPROM routines)
brom_mt3301
- GPS OTA FOR SAMPLE CODE IN MEDIATEK PLATFORM
stm32uart
- STM32 uart source code
例11-1 UCOSIII消息传递
- UCOS3 消息传递 ，实验，基于STM32F103ZET6(UCOS3 message passing, experiment, based on STM32F103ZET6)
SMG
- 实现将BCD码动态扫描显示在数码管上--verilog(The realization of dynamic scanning BCD code displayed on the digital tube --verilog)
AD9854programme
- 利用FPGA启动AD9854进行扫频，用于频率特性测试仪。并通过Wify模块发送数据(FPGA is used to start AD9854 for frequency sweep, and is used for frequency characteristic tester. And send data through the Wify module)
新型的按键扫描程序
- 新型的按键扫描程序.rar 我非常坚信这种按键处理办法的便捷和高效，你可以移植到任何一种嵌入式处理器上面，因为C语言强大的可移植性。 同时，这里面用到了一些分层的思想，在单片机当中也是相当有用的，也是本文的另外一个重点。(I'm very confident that this button handling is easy and efficient, and you can transplant it to any embedded processor because of the po