资源列表
YSF1_HAL-124. GSM模块例程
- YSF1_HAL-124. GSM模块例程1(YSF1_HAL-124. GSM module routine)
记录开机后按键第一次按下后抬起的时间
- 中断配置按键(Interrupt configuration key by interrupting)
chap4
- 4．1 实验1： 6713DSK 实验设备的认识和测试实验 4．2 实验2： CCS 编程环境下编程和调试实验 4．3 实验3： 基本 I/O 接口操作和线性汇编混合编程 4．4 实验4： 音频信号采集和处理实验 4．5 实验5： 定时器中断与中断处理实验(4.1 cognition and test experiment of experimental 1:6713DSK experimental equipment 4.2 programming and debugging ex
stm32CtlBoard_oldbroad_1121_1619
- stm32+l6470控制两路步进电机。 监控摄像头球机驱动程序(Stm32+l6470 controls two step motor. Monitor camera ball driver)
Usart
- 将MCU上集成的传感器值通过串口传输到阿里云服务器上，同时也可以通过上位机下发指令控制MCU上开关通断(The sensor values integrated on the MCU are transmitted to the Ali cloud server through the serial port. At the same time, the switch on the MCU can be controlled through the upper computer to contr
ADC+DMA+KEYPAD
- 结合stm32F07实现将采集模拟电压转换成数字信号在显示屏上显示ADC模拟电压采集，并将采集到电压传输上位机，同时手机接收到相关指令可以控制开关通断(Combined with stm32F07, the analog voltage is converted to digital signal. The ADC analog voltage acquisition is displayed on the display screen, and the voltage is transmitt
KAUSHD
- 单片机知识，制作简单，c语言开发 容易操作(Single chip knowledge and development of simple C language Easy to operate)
character_string
- 通过扫描实现LED中汉字显示，硬件外联的简单实现(The realization of Chinese character display in LED by scanning)
txrx
- FPGA串口通信的简单示例程序，分为TX和RX两个模块(A simple program for FPGA serial communication)
sigrok-firmware-fx2lafw-0.1.5.tar
- sigrok fx2lafw firmware
pid六轴I2c的库
- Ardiono PID六轴和I2C通讯的库文件(The library file of the Ardiono PID six axis and I2C communication)
mySystemTest1
- 基于FreeRTOS的麦轮四轮底盘系统模型，CAN和USART通讯(this is a system base on FreeRTOS, and you can build your robotics system on this especially on this code. Communiciate by USART and CAN!)