资源列表
NORsw
- ADM5120P bootloader image in .s19 format for 4MB flash 32MB SDRAM board
dumpling
- 这是一个使用IAR的C/C++开发的嵌入式软件，使用AVR的8位单片机。内嵌有uC/OSII的嵌入式操作系统。功能：通过温度传感器采集油温，并根据油煎饺子的经验油温数据，来控制炉子的温度。该软件已在饮食行业大量使用。-This is dumpling controled software which use ucOS RTOS with IAR C/C++ compiler.
code_ok
- 电话拨号ht9200,ht9270源码，51下测试通过-Telephone dial-up ht9200, ht9270 source, 51 under the test
tft4137
- TFT4137液晶模块驱动。驱动芯片为S6D0139 (片内172800字节GRAM,即240*320*18/8-TFT4137 LCD driver module. Driver IC for S6D0139 (byte 172800-chip GRAM, that is, 240* 320* 18/8),
boat_drive
- 基于LM3S1138和NRWF508的无线遥控船-LM3S1138-based and wireless remote control boat NRWF508
ARMDSP
- 用于电能质量在线装置 这是基于ANM+DSP的程序 不是太完善-FGSDGSSFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFVBCXBGGGG
AD
- 基于TMS320F2812的TLV5618程序-TLV5618 procedures based on the TMS320F2812
ExampleLPC2000_USB
- LPC2000 family example of how to control the USB.
STR750
- 这是采用ST公司的ARM7芯片开发的一段源代码，由于不是很复杂所以可以让初学者更容易接收！-This is the use of ST' s ARM7 chip developed for some source code, because there is not very complicated so that beginners can more easily receive!
LP2131_Motor
- 基于LPC2131的步进电机S形加减速控制,包含整个工程文件，并附上word文档的连接电路图，和必要的说明，是很好的熟悉ARM嵌入式开发和步进电机控制的资料。-LPC2131 based on the stepper motor S-shaped acceleration and deceleration control, including the project files, word documents together with the connection circuit, and t
glcd
- ep9315 glcd lib for linux 2.6
ISP1582_MS_firmware
- NXP ISP1582 的usb设备U盘软件。-The USB mass storage device firmware for NXP s ISP1582 chip.