资源列表
videolinux
- 基于S3c2440嵌入式视频采集。图片采集保存-Based S3c2440 embedded video collection. Image acquisition saved
MIPI_VIDEO-MODE-TEST-PROGRAM
- 此例程是基于ARM9+SSD2825构架的高清LCD测试程序，可用于测试MIPI_VIDEO和MIPI_command 模式下的WVGA,FWVGA,QHD等高清手机LCM。支持4通道MIPI接口，SSD2825是 晶门科技的高速4通道MIPI传输器。-This routine is the HD LCD based on ARM9+SSD2825 architecture test program can be used for high-definition WVGA, FWVGA, QHD
html-camera-boa_cgi
- 嵌入式摄像头网页拍摄boa_cgi源码,进行同类功能设计可以作为一个参考。-htlm camera take picture code.htlm add cgi code.
qt-zip-or-unzip
- qt 压缩解压缩文件和文件夹源码，嵌入式应用资源一般都比较紧张，有需要的参考下。-qt zip or unzip a file/a folder,qt code.a project.
Qt-draw-a-curve
- Qt用串口读单片机温度数据画动态波形曲线,完整项目源码。-Qt draw a curve，the date receive from mcu.
my_cgi
- 嵌入式ARM远程视频监控项目中的一个CGI程序，通用网关接口程序，还要配置相应的网页。-Embedded the ARM remote video monitoring project in a CGI program, the Common Gateway Interface program, but also configure the appropriate page.
gpio_IRQ.tar
- 在DM365下实现的用一个GPIO脚实现中断，中断号，测试代码等内容完整。-DM365 under achieve GPIO pin interrupt, the interrupt number, test code is complete.
v4l
- 基于S3C2410视频采集设计,集成从摄像头采集数据写framebuffer实现-The designing for video capture
fimc
- 三星的照相机的驱动。包括ov9650和fimc控制器的驱动和v4l2的中间层-Samsung camera driver. Including ov9650 and fimc controller driver v4l2 middle layer
WINPM.EXE.tar
- 分区工具，可以在windows下将sd卡分成fat32和ext3或ext2分区-Partitioning tool, under the windows of the sd card into fat32 and ext3 or ext2 partition
2th
- 最简单的bootloader的编写步骤： 1. 初始化硬件：关看门狗、设置时钟、设置SDRAM、初始化NAND FLASH 2. 如果bootloader比较大，要把它重定位到SDRAM 3. 把内核从NAND FLASH读到SDRAM 4. 设置"要传给内核的参数" 5. 跳转执行内核 -The easiest the bootloader preparation steps: 1. Initializes the hardware: Off watchdog, set
5.1_color_lcd_test
- 基于ARM，S3C2410的液晶显示，实现ASCII码，汉字，横线，竖线的显示-Based on ARM S3C2410 LCD ASCII, Chinese characters, horizontal line, vertical line display