资源列表
ARMv1_uCGUI
- 开发环境:ADS 1.2 目标平台:ARM:S3C44B0 显示屏:tft4.3" 480*272(24Bit) GUI:UCGUI324 项目功能:实现UCGUI在ARM7和彩屏LCD上成功移植 Seloo@tom.com 2008-10-12-Development Environment: ADS 1.2 target platforms: ARM: S3C44B0 display: tft4.3
51ECLOCK
- 本文件中包含了用单片机51来实现一个功能全面的电子钟的程序以及实验报告,并且附有详细的流程图。-This document contains the MCU 51 to achieve a full-featured electronic clock procedures, as well as experimental reports, and accompanied by a detailed flow chart.
ST-LINKII-KEIL_Driver
- ST-LINKII-KEIL 驱动 拷贝到keil\arm\bin目录下 keil 3.22a以上版本-ST-LINKII-KEIL-driven copy to keilarm in directory keil 3.22a above
1602+18b20
- 基于c51单片机的18b20实时温度检测,1602液晶显示实时温度。-C51 MCU-based real-time temperature 18b20 detection, real-time temperature of liquid crystal display 1602.
p89v51rc2IAP
- P89V51RC2FA 单片机的IAP程序-IAP procedures P89V51RC2FA SCM
serial-nrf9e5
- nrf9e5带超时无线收发:从串口接收数据(靠超时判断而不是字节判断),无线发送后,接收端将数据显示在串口。-nRF9E5 with overtime wireless transceiver: receiving data from the serial port (rather than relying on overtime to determine byte judge), wireless send after the receiving end the data displayed
Wireless remote control system for towercrane base
- W ireless rem ote control system for tower crane based on M SP430 and nRF905:介绍了一种基于无线遥测技术的塔吊遥控系统,该系统以MSP430超低功耗l6位微控制器和无 线收发芯片nRF905为核心。系统采用软件编码和硬件译码的方式提高了系统的抗干扰能力,系统发 射器采用定时扫描、接收器采用无记忆输出控制方式,提高了系统可靠性,该系统可广泛应用于塔吊等 一般的工业遥控系统中。-W ireless rem
4-4keyboard
- 我自己编写的atmega16的4*4键盘程序-I have written ATmega16 4* 4 keyboard procedures
430WDT
- MSP430的WDT看门狗应用的C语言源码-MSP430 application of the WDT watchdog C language source
msp430F4XX2LCD
- 利用两片MSP430F4XX实现额外的液晶驱动-MSP430F4XX the realization of the use of two additional LCD driver
nios_irq
- 在niosII 中实现按键触发中断使数码管或LED显示-In achieving niosII interrupt trigger button or LED digital tube display
dianzizhong
- 基于凌阳单片机数字电子钟开发源代码,是已经调试好的源代码,可以直接用。-Sunplus based on the development of single-chip digital clock source code, is already a good debugging source code, can be directly used.