资源列表
eluosi
- 单片机用的俄罗斯方块程序，用128x64的液晶显示。-Singlechip procedures used in the Russian box, using the LCD 128X64.
DS18b20
- 基于keil c51软件的DS18B20的程序,可应用于温度控制系统-Based on keil c51 software DS18B20 procedures can be applied to temperature control system
NTC
- NTC热敏电阻测温，编译环境，AVR-G-NTC thermistor temperature measurement, the compiler environment, AVR-G
bingxiang
- 本要求适用于Microcon-T02半导体冰箱控制板（以下简称控制板）。本控制板由电源板、显示控制板两部分组成。-The requirements apply to Microcon-T02 semiconductor refrigerator control panel (hereinafter referred to as the control panel). The control panel from the power supply board, display panel is
24c02readandwrite
- 24C02的读写时序和源码，经测试能用，可以向24CXX推广。-24C02 timing and source of reading and writing, can be used by the test can be made to promote 24Cxx.
1602B_LCD
- AVR单片机 液晶菜单程序 使用的1602B_LCD液晶-AVR LCD menu Singlechip procedures used in liquid crystal 1602B_LCD
ARMv1_uCGUI
- 开发环境:ADS 1.2 目标平台:ARM:S3C44B0 显示屏:tft4.3" 480*272(24Bit) GUI:UCGUI324 项目功能:实现UCGUI在ARM7和彩屏LCD上成功移植 Seloo@tom.com 2008-10-12-Development Environment: ADS 1.2 target platforms: ARM: S3C44B0 display: tft4.3
51ECLOCK
- 本文件中包含了用单片机51来实现一个功能全面的电子钟的程序以及实验报告，并且附有详细的流程图。-This document contains the MCU 51 to achieve a full-featured electronic clock procedures, as well as experimental reports, and accompanied by a detailed flow chart.
ST-LINKII-KEIL_Driver
- ST-LINKII-KEIL 驱动 拷贝到keil\arm\bin目录下 keil 3.22a以上版本-ST-LINKII-KEIL-driven copy to keilarm in directory keil 3.22a above
1602+18b20
- 基于c51单片机的18b20实时温度检测，1602液晶显示实时温度。-C51 MCU-based real-time temperature 18b20 detection, real-time temperature of liquid crystal display 1602.
p89v51rc2IAP
- P89V51RC2FA 单片机的IAP程序-IAP procedures P89V51RC2FA SCM
serial-nrf9e5
- nrf9e5带超时无线收发：从串口接收数据（靠超时判断而不是字节判断），无线发送后，接收端将数据显示在串口。-nRF9E5 with overtime wireless transceiver: receiving data from the serial port (rather than relying on overtime to determine byte judge), wireless send after the receiving end the data displayed