资源列表
BootLosder_Training
- 基于CAN总线的Bootloader培训资料！-Based on CAN Bus Bootloader training materials!
TaTb_Fre_Meter
- MSP430测频1HZ - 33MHz用两个定时器TATB一个计数一个计时-MSP430 measured frequency 1HZ- 33MHz timer using two TATB count a time
Bootloader-for-HCS12X
- Bootloader in C for Freescale HCS12X. Uses serial SCI (UART) to load S19 files. It does not make use of XGATE
E1
- IIC总线驱动程序，msp430控制EEPROM（AT24C02）读写，指定地址读写，连续地址读写-IIC bus driver, msp430 control EEPROM (AT24C02) read and write, read and write the specified address, consecutive address read and write
hc-sr04
- 89c52单片机。用HC-SR04超声波测距，然后用1602的液晶来显示。-89c52 microcontroller. HC-SR04 ultrasonic ranging, and then the 1602 LCD display.
danpianji-
- 采用51单片机，开发工具为KEIL.主要功能是实现一个多功能温度计。采用1602液晶显示和配合上位机软件共同完成环境温度的检测与报警功能。系统可以通过按键或者上位机修改报警温度上下限。并将数值保存在外置的EEPROM中，以便开机的时候自动加载。-This work is entirely in accordance with the commercial and practical design requirements to enhance the operation of the syst
HY-RedBull-V3.0-2011.6.14
- 按键输入，演示灯亮，ARM开发板。会 hi会回家-Key demo lights
wsd_setup_v705
- AD公司Aducxxx单片机的下载软件，7.05版本，实际使用过程中，注意板子加电电压需高于5V，否则容易烧写不成功。-The AD the company Aducxxx microcontroller download software, 7.05 version of the actual use of the process, attention to the board the power voltage should be higher than 5V, or easy progra
GPIO_KEYINPUT
- STM32F103RBT6两KEY键控制LED闪烁，按键灯亮，不按灯灭-STM32F103RBT6 two KEY key to control the LED is blinking, button lights do not light off
HCTL-2032
- hctl2032总线方法 晶振 单片机 系统开发-hctl2032 c
PT_LEDDemos
- 操作系统内核protothread，的应用实例，难道的操作系统内核protothread在5081单片上的应用代码，LED多任务运行实例，测试通过-Application instance of the operating system the kernel protothread, Is the operating system kernel protothread on the 5081 single-chip application code running instance of the
TSC2046-drv
- 触屏控制芯片TSC2046，3.0寸400X240触摸屏驱动程序，里面包含UP,DOWN,MOVE,NONE触控动作机制，使用STC12C5A60S2单片机驱动，完善的测试程序。-TSC2046 touch screen control chip, 3.0 inch 400X240 touch screen driver, which contains UP, DOWN, MOVE, NONE touch action mechanism, use STC12C5A60S2 single-chi