资源列表
SoftUart
- 使用MSP430单片机的定时器A,模拟UART通信。程序在IAR环境下调试通过,实际应用在2.45M的主频下,波特率19200能够可靠通信。-MSP430 MCU timer A simulation of the UART communication. Program debug in IAR environment through practical application in 2.45M clock speed 19200 baud rate for reliable communica
IRQ_flow_overturn
- 飞思卡尔HCS12X系列的IRQ中断模块,下降沿控制PB口LED流水灯反显的工程,我在codewarrior 5.1上建的工程,运行在芯片MC9S12XDP512的开发板SK-S12XDP512-A上面。-Freescale HCS12X series IRQ interrupt module, down along the PB mouth water control LED lamp of reverse engineering, I in codewarrior 5.1 is built
STM32-TIM-TRGO-ADC
- STM32 TIM1硬件触发ADC注入式转换 已调试-STM32 TIM1 TRGO ADC
nokia-5110--sizhong
- 基于51单片机 NOGIA 5110时钟显示程序 ,方便研究,易懂-Based on 51 SCM NOGIA 5110 the clock display program, convenient, easy to understand
sk-tdm-v1
- 用m9sdz60的CAN总线控制汽车空调,内有PGN设定等,在宇通车上模拟过.-m9sdz60 CANbus
DAC
- msp430f149 DAC5571 iic总线 DAC转化参考代码-msp430f149 DAC5571 iic bus DAC conversion of the reference code
no2.left_CODE_right_LED_SHOW
- 本程序是AVR单片机ATMEGA16的从左至右的LED灯流水程序,单片机教程:http://www.ipbb.cn,初学者的朋友们可以参考一下!-This program is the AVR microcontroller ATMEGA16 from left to right LED light water program, microcontroller tutorial: http://www.ipbb.cn beginner friends you can refer to
004liu
- 基于icc avr atmega16 流水灯程序设计-Icc avr atmega16 light water-based programming
UART
- 此程序是用msp430g2553通过串口与上位机通信,-This program is to communicate with the host computer through the serial port using msp430g2553
Flashwriten-and-read
- 此程序是对msp430g2553flash的读和写程序,使得430的大量存储空间可以得到应用-This program is read and write to msp430g2553flash
Dc-generator-speed
- 直流发电机的调速程序,使用的是STC12C5A的单片机,采用PWM技术来调节他的速度,简单便捷。-DC generator speed control program use is microcontroller of STC12C5A, and PWM technology to adjust his speed, simple and convenient.
duoji
- 本文档是基于msp430f149单片机的舵机控制程序,经本人测试绝对可用。-This is a program of steering engine.