资源列表
RT3-electronic-thermometers-source
- RT3电子温度计源程序,STC12C5A60S2系列 12MHz晶体,每1分钟左右更新一次温度数据,采用单片机空闲模式,LM75掉电模式。-RT3 electronic thermometers source, STC12C5A60S2 series 12MHz crystal, updated once every 1 minute or so the temperature data, using SCM idle mode, LM75 power-down mode.
HX711PLCD1602PSTC12xx-V2.4
- 【淘宝购.电子秤开发板配套资料V2.4】-hx711 and lcd1602 ,stc12xxx
ADC
- STC12C5A60S2ADC转换,并在TFT液晶显示屏上显示。-STC12C5A60S2ADC conversion, and in the TFT LCD display.
Relay-and-TRIAC-Control-Power-Device
- 继电器及双向可控硅控制照明设备,C语言编程,并配有proteus仿真电路。-Relay and triac control lighting equipment, C language programming, and is equipped with proteus simulation circuit.
MS5611
- MS5611是一种精度较高的气压计,用于测量高度和温度,先配置,后利用定时器定时读取传感器的数据,并解算出高度-MS5611 is a high precision barometer for measuring altitude and temperature, the first configuration, after the use of timers regularly reads the sensor data, and solves for height
c51_Freemodbus
- FreeMODBUS一个奥地利人写的Modbus协议。它是一个针对嵌入式应用的一个免费(自由)的通用MODBUS协议的移植。Modbus是一个工业制造环境中应用的一个通用协议-FreeMODBUS an Austrian write Modbus protocol. It is an embedded application of a free (free) generic MODBUS protocol transplant. Modbus is an industrial manufactu
TSM12_Micom_CPGM
- ADS 触摸IC TSM12 的驱动,TSM12 是12位按键,适用大部份单片机-mcu control TSm12 driver
lanya
- 51单片机使用无线蓝牙模块的发送和接收程序。能稳定的传输信息。利用单片机串口通信,蓝牙模块就相当于无线串口。-51 single-use wireless Bluetooth module to send and receive procedures. Stable transmission information. The use of single-chip serial communication, Bluetooth wireless serial module is equivalen
IR-signal-learning-code
- 红外信号学习代码,只有简单的传输,存储功能,见谅-IR signal learning code, only a simple transmission, storage, forgive me
MDK-emWIN516
- NXP LPC1788 移植emWin516 图形界面工程样例,7寸LCD外扩 RAM和Flash。-NXP LPC1788 transplant emWin516 graphical interface engineering sample, 7-inch LCD external expansion RAM and Flash.
BLE_CC254x_140
- TI最新的低功耗BLE蓝牙4.0软件开发包版本号4.0-TI' s new low-power Bluetooth 4.0 BLE software development kit version 4.0
1602
- 本程序运用MSP430G2553来驱动LCD1602液晶显示,已经调试成功-The procedures used to drive LCD1602 LCD MSP430G2553 has been successful debugging