资源列表
MODBUS-RTU
- modbus rtu程序主程序，定义了40000,30000,10000,20000开始的继电器和寄存器数据访问，其它辅助文件可联系我-modbus rtu main progrom
General_IO_simulation_AD(RC)
- 普通IO型单片机通过电阻电容(RC)充放电实现AD检测，本案例是海尔芯片。-Ordinary IO type microcontroller through the resistance capacitance (RC) charge and discharge to achieve AD detection, this case is Haier chip.
IAP
- IAP 网络升级的几个关键代码，包含了TFTP升级，串口升级，FLASH烧写的代码-Several key codes IAP network upgrades, including the TFTP upgrade, serial port upgrade, FLASH programming code
LTC6803-G128_14
- 电池管理程序，单电压采样，均衡，温度采样，LTC6803的使用，是学习电源管理的好参考程序。-Battery Management
ATmega8_USART_FRAME
- 串口帧发送接收测试程序，采用ATmega88单片机，时钟16MHz，ICCAVR工程。-A source code demonstrates sending/receiving serial frame. MCU is ATmega88, clock frequency is 16 MHz， built by ICCAVR.
1302
- 单片机万年历设计，把从ds1302读取的数据显示在lcd1602.并且可以对时间进行设置-SCM calendar design, the data read the ds1302 displayed in lcd1602. And can be set for time
PWM
- 利用MSP430F149控制输出PWM波来调节LED灯的亮度-Use MSP430F149 control output PWM wave to adjust the brightness of LED lights
CHERAQ
- This is a bascom code for led blinker project with atmega8 witch uses PWM tecnicues to do this
mainSend
- 1、Cmos Sensor OS 测试； 2、主控单片机型号：STC15F4K60S4 3、模拟电子开关：CD4051 CD4067BM96 4、单片机控制模拟电子开关自动采集被测Sensor 各PIN的导通压降，将数据通过串口 发送至上位机，上位机接收数据并对数据进行分析判断，给出最终的OS测试结果； 5、单片机10位精度AD 电压采集； 6、支持单片机串口通信；-1, Cmos Sensor OS test 2, the master SCM model: STC1
MyProject
- pic16f1527芯片的串口usart通信-uart chip serial communication pic16f1527
STM32-UART
- STM32F103 uart 串口通信程序 基于MDK平台完整工程-STM32F103 uart MDK
STM32-IIC
- STM32 IIC 源码完整工程 基于MDK开发环境-STM32 IIC MDK